Dialogic IMG 1010 Краткое руководство по эксплуатации - Страница 11

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Шлюз Dialogic IMG 1010. Dialogic IMG 1010 18 страниц. Connecting dc power
Также для Dialogic IMG 1010: Руководство по установке (6 страниц), Краткое руководство по эксплуатации (11 страниц), Краткое руководство по эксплуатации (10 страниц), Краткое руководство по эксплуатации (10 страниц), Руководство по установке (9 страниц), Краткое руководство по эксплуатации (4 страниц)

Connecting DATA 0 Interface

The information below will provide the user with a basic setup sequence for connecting the

IMG 1010 to a VoIP network utilizing SIP or H.323 signaling. The DATA interfaces are Gigabit-

Ethernet ports and are typically used to pass RTP traffic. Depending on how the ports are

configured, they can be configured to be on the same secure IP network as the CTRL 0

interface (Management Network), or can be connected to a separate public network to be

used for VoIP Signaling and RTP traffic.

1. Connect the cables as shown in the figure below. The figure below displays the DATA 0

interface being connected to a public network.

2. The DATA 0 interface located on the rear of the IMG 1010 and is a Gigabit-Ethernet

port dedicated to VoIP Bearer traffic (RTP) or SIP/H.323 signaling. Refer to the the

topics under the IMG 1010-Installation and Setup Guide > IMG 1010-Hardware

Installation book for more information on connecting to this interface.

Note: The IP addresses for these ports are assigned through the ClientView GUI. For more

information on configuring these interfaces, refer to the IP Address and IP Network

(Interface) topics in the ClientView Pane Reference section of the online documentation.

IMG 1010 Quick Start Guide