Overview:
The procedures below pertain to the removal and installation of the Dialogic
which is located on the Dialogic
installation be performed only by qualified technical personnel who are familiar with this procedure.
Please read and fully understand the procedures below prior to performing the removal/installation.
Electrostatic Discharge Protection:
Electrostatic discharge from your body can damage integrated circuits during installation; therefore
Electrostatic Discharge Protection (EDP) must always be used. Electrostatic Discharge protective
straps, shoes, or mats must be used when working with electronic components.
Warranty Information
For applicable warranty information see the 'Hardware Limited Warranty' section above or visit our
website at
http://www.dialogic.com/warranties
Equipment, Tools, and Materials Required
Review the packing list to ensure that the items listed below as "Supplied" have been provided.
Should any discrepancies exist between what you received and what is listed below as "Supplied",
please contact your Sales representative.
Supplied
®
Dialogic
IMG 1010 VoIP Module (Dialogic supplied).
(4) M3 x 5 Phillips pan head screws. (Dialogic supplied).
Not Supplied
A technician's workbench meeting IPC-A-610D ESD requirements
Mountz Model TLS0406 torque tool or equivalent
Phillips head Bit (#1)
Phillips screwdriver (#1)
Remove Dialogic
®
1. Switch power to OFF (O) at rear of docking station.
2. Loosen the two ejector captive fasteners located on each side of the front panel.
3. Lift the ejectors upward and pull to unseat the tray from the docking station.
4. Remove 1010 Motherboard. See Diagram 1 below
Dialogic Corporation
®
IMG 1010 Motherboard. We recommend that removal and
IMG 1010 Motherboard
Diagram 1
Part # 07-8740-02
®
IMG 1010 VoIP Module
Page 4 of 9
Печатать страницу