AllPondSolutions 500-HO+ Руководство - Страница 4
Просмотреть онлайн или скачать pdf Руководство для Системы фильтрации воды AllPondSolutions 500-HO+. AllPondSolutions 500-HO+ 17 страниц. Aquarium hang-on filter with uv
Печатать страницуELECTRIC
This unit comes complete with a generous supply of 3 core cable, however
should any additional cable be required, the use of an approved waterproof
cable connector with a proper rating is essential. A cord rated for less amperes
or watts than the appliance rating may overheat.
Please Ensure:
The power supply must be earthed and fused at 3amps.
·
You regularly inspect the cable for damage and deterioration.
·
Do not connect to any voltage other than that stated.
·
You consult a qualified electrician if in doubt about any aspects of
·
wiring.
Important: The power supply must be earthed and fused at 3amps. Regularly
inspect the cable for damage and deterioration. Consult a qualified electrician if
in doubt about any aspects of wiring.
INSTALLATION & USE
Please read the below instructions carefully before beginning to set up your
filter. DO NOT CONNECT THE UNIT TO THE MAINS UNTIL SET UP IS
COMPLETE AND UNIT IS FILLED WITH WATER.
Important installation information:
When installing your filter, the minimum water level in the tank should be
·
no more than 6 cm (2.25 inches) below the aquarium rim.
The inlet pipe should NOT be positioned too close to an air stone, aeration
·
device or the output valve to avoid reducing the effectiveness of the filter.
Firstly, unpack the unit and identify all parts using the parts diagram in this
instruction manual.