AllPondSolutions AqueECO 16000 Руководство - Страница 5

Просмотреть онлайн или скачать pdf Руководство для Насосы для пруда AllPondSolutions AqueECO 16000. AllPondSolutions AqueECO 16000 14 страниц.

INSTALLATION & USE

The All Pond Solutions AquaEco pump range can be used to circulate water or

to pump to and from a separate ﬁltration system or water features using

suitable ﬂexible hose (ﬂexible hosing sold separately). It can only be used with

freshwater and tropical set ups.

Please read the below instructions carefully before beginning to set up your

pump. DO NOT CONNECT THE UNIT TO THE MAINS UNTIL SET UP IS

COMPLETE AND UNIT IS FILLED WITH WATER.

1. Connect the required attachments - start oﬀ by attaching the adaptor to the

unit. You can then attach the rest of the parts in this order: hosetail o-ring,

hosetail, hosetail nut.

Inlet hose - if an inlet hosetail is required, you can

follow the above instructions to assemble it after you

remove the inlet guard (see image on the right).

2. Position the pump - fully submerge your

AquaECO unit. Place it on a level and sturdy surface

at the bottom of your pond, this is to avoid silt

entering the pump causing excessive wear and

increasing ﬁlter cage cleaning.

3. Connect your AquaECO pump to the mains - Connect the unit to the mains

using a residual current device (RCD) for additional safety.

4. Switch on your unit at the mains - turn on the operation by switching on

the unit at the mains.