Dialogic Vision TIGI2U Установка - Страница 12

Просмотреть онлайн или скачать pdf Установка для Сервер Dialogic Vision TIGI2U. Dialogic Vision TIGI2U 15 страниц.

Печатать страницу

Installing the Dialogic® Vision™ Server TIGI2U

Compliance statements

EU R&TTE statement

This product is intended to be connected to the following public telecommunication networks:

•

2048 kbit/s 120 ohm digital structured or unstructured ONP leased line in all EU countries.

•

Euro-ISDN Primary Rate Access in all EU countries (for servers with up to two line card interfaces and

no signaling interface).

For more information, refer to http://www.dialogic.com/declarations/default.htm.

FCC Part 15 Class A statement

This board has been tested and found to comply with the limits for a Class A digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications. Operation of this equipment

in a residential area is likely to cause harmful interference, in which case the user will be required to

correct the interference at his or her own expense. Modifications not expressly approved by Dialogic may

void the FCC granted authority to operate the equipment.

FCC Part 68 statement

This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the

bottom of this equipment is a label that contains, among other information, a product identifier in the

format US:EMCXDNANXXXXXXXX. If requested, this number must be provided to the telephone company.

The telephone company will need to know the Service Order Code, the Facility Interface Code, and the

wiring configuration (or USOC jack type) corresponding to the service you are ordering, as shown in the

following table:

Service type

4-wire 1.544 Mbps (DS1) with super frame (SF),

alternate mark inversion (AMI), no line power, 100

ohms.

4-wire 1.544 Mbps (DS1) with SF, bipolar with

eight-zero substitution (B8ZS), no line power, 100

ohms.

4-wire 1.544 Mbps (DS1) with extended super

frame (ESF), AMI, no line power, 100 ohms.

4-wire 1.544 Mbps (DS1) with ESF, bipolar with

eight-zero substitution (B8ZS), no line power, 100

ohms.

If the equipment causes harm to the telephone network, the telephone company will notify you in advance

that temporary discontinuance of service may be required. If advance notice is not practical, the telephone

company will notify you as soon as possible. Also, you will be advised of your right to file a complaint with

the FCC if you believe it is necessary.

The telephone company may make changes in its facilities, equipment, operations, or procedures that

could affect the operation of the equipment. If this happens the telephone company will provide advance

notice so that you can make necessary modifications to maintain uninterrupted service.

This product is not intended for customer repair.

If you experience trouble with this equipment, contact Dialogic for warranty and repair information. The

telephone company may ask that you disconnect this equipment from the network until the problem has

been corrected or until you are sure that the equipment is not malfunctioning. This board may not be

connected to party lines or used on coin service lines provided by the telephone company. The part 68

affidavit for digital and subrate services is included separately.

Arrow.com.

Downloaded from

Facility

Service

interface code

order code

04DU9.BN

6.0N

04DU9.DN

6.0N

04DU9.1KN

6.0N

04DU9.1SN

6.0N

USOC

jack type

RJ-48C