Miller Spectrum 300 Руководство пользователя - Страница 20
Просмотреть онлайн или скачать pdf Руководство пользователя для Сварочная система Miller Spectrum 300. Miller Spectrum 300 32 страницы. Air plasma cutter
Также для Miller Spectrum 300: Руководство пользователя (21 страниц), Руководство пользователя (32 страниц)
Печатать страницу
- 1. Specifications for Units Connected to a 30 Ampere, 115 Volt Circuit or a 15 Ampere, 230 Volt Circuit
- 2. Specifications for Units Connected to a 20 Ampere, 115 Volt Circuit or a 10 Ampere, 230 Volt Circuit
- 3. Connecting Work Clamp and Gas/Air Supply
- 4. Section 5 - Maintenance & Troubleshooting
- 5. Troubleshooting
- 6. Section 6 - Electrical Diagram
- 7. Section 7 - Parts List
- 8. Options and Accessories
4-1. Controls
1
Setting Gas/Air Pressure
1
70-150 PSI
(483-1034 kPa)
1
Output Control
Use control to set cutting output.
The yellow zone is for use on 20 A or greater
primary circuits.
Place control in Gas/Air Set position to safely
adjust gas/air pressure. Only gas/air circuit
is activated.
If 20-25 amperes of cutting output is used
with 115 VAC input power, and the overload
protection on the input power circuit fre-
quently opens, either reduce the cutting out-
OM-2210 Page 16
SECTION 4 – OPERATION
2
3
7
6
Requires
Supply
put and/or the cut time or find more adequate
power (see Section 3-8).
2
Trouble Lights (See Section 5-2)
3
Ready Light
Use light to tell if unit is ready for operation.
Ready light comes on when Power switch is
placed in On position, indicating that all safe-
ty shutdown systems are okay.
If Ready light does not come on, check
Trouble Lights.
4
Power Light
5
4
Set To
60 PSI (414 kPa)
5
Power Switch
Setting Gas/Air Pressure
6
Air Filter/Regulator
7
Pressure Adjustment Knob
Place Output control in Gas/Air position and
turn on gas/air supply. Lift knob and turn to
adjust pressure. Push knob down to lock in
setting.
Place Output control in desired cutting
output.
Ref. 801 306-C / Ref. 192 492