Miller Spectrum 375 X-TREME Руководство пользователя - Страница 27

Просмотреть онлайн или скачать pdf Руководство пользователя для Сварочная система Miller Spectrum 375 X-TREME. Miller Spectrum 375 X-TREME 40 страниц. Air plasma cutting and gouging
Также для Miller Spectrum 375 X-TREME: Руководство пользователя (40 страниц), Руководство пользователя (36 страниц), Руководство пользователя (36 страниц), Руководство пользователя (44 страниц)

Печатать страницу
Miller Spectrum 375 X-TREME Руководство пользователя

6-5. Sequence Of Cutting Operation

Connect work clamp to a clean, paint-free
location on workpiece, as close to cutting
area as possible.
!
The pilot arc starts immediately
when trigger is pressed.
Raise trigger lock and press
trigger. Pilot arc starts.
Adjust torch speed so
sparks go thru metal and
out bottom of cut.
.
A complete Parts List is available at www.MillerWelds.com
Pause briefly at end of
cut before releasing trigger.
90
For standard (shielded) cutting, place drag shield on edge
of metal. For extended (non-shielded) cutting, use 1/8 in.
(3.2 mm) standoff distance (dragging tip will reduce tip life).
After cutting arc starts, slowly
start moving torch across metal.
Postflow continues for approx. 20 seconds
after releasing trigger; cutting arc can be
instantly restarted during postflow by raising
trigger lock and pressing trigger.
Ref. 254 087-A
OM-253 555 Page 23