Miller Syncrowave 351 Руководство пользователя - Страница 22
Просмотреть онлайн или скачать pdf Руководство пользователя для Сварочная система Miller Syncrowave 351. Miller Syncrowave 351 42 страницы. Arc welding power source
Печатать страницу4-1. Standard Controls
1
2
3
13
.
Place 4 switches in upper left corner up
for SMAW and down for GTAW.
1
Mode Switch
Switch selects SMAW or GTAW.
2
Amperage Control Switch
Switch selects front panel or remote amper-
age control.
3
Output Switch
Y Weld output terminals are energized
when Output switch is On and Power
is On.
Switch selects front panel or remote output
control.
4
High Frequency Switch
For GTAW, use switch to select continuous
OM-354 Page 18
SECTION 4 – OPERATION
4
6
7
8
12
HF, HF for arc starting only, or no HF.
5
High Frequency Control
For GTAW, use control to set HF intensity.
Set as low as possible.
6
Ammeter
7
Voltmeter
8
Amperage Adjustment
Control
.
Control can be turned past the minimum
and maximum stops without damage to
the control.
Control requires 3 turns to go from minimum
to maximum. Use ammeter to preset amps.
For remote amperage control, front panel
control setting is the maximum amperage
available. For example: If front panel control
9
10
11
5
is set to 200 A, the range of the remote am-
perage control is 0 to 200 A.
9
Arc/Balance Control
Control functions as an arc control for
SMAW DC output and as a balance control
for AC output (see Section 4-2 for more in-
formation).
10 Postflow Time Control
Control sets length of time gas flows after
welding stops.
11 Power Switch Pushbuttons
12 Output Selector Switch
13 High Temperature Shutdown Light (CE
Models Only)
Lights when unit overheats and shuts down
(see Section 3-2).
Ref. ST-154 795-B / Ref. ST-149 842-E