Miller Trailblazer 251 Руководство пользователя - Страница 28

Просмотреть онлайн или скачать pdf Руководство пользователя для Сварочная система Miller Trailblazer 251. Miller Trailblazer 251 48 страниц. Engine driven welding generator

Miller Trailblazer 251 Руководство пользователя

7-6. Adjusting Engine Speed

10
8
9
OM-485 Page 24
6
Left Side
4
11
3
2
±
2200
100 rpm
±
3700
50 rpm
5
7
1
2
Top View
Tools Needed:
1/4, 3/8 in
After tuning engine, check engine
speeds with a tachometer (see
table). If necessary, adjust speeds
as follows:
Start engine and run until warm.
Turn A/V control to max.
Idle Speed Adjustment
1
Throttle Solenoid
2
Mounting Screw
Loosen two mounting screws.
3
Governor Arm
4
Carburetor
5
Idle Speed Screw
Pull governor arm away from
carburetor and hold while making
the following adjustment:
Turn idle speed screw until engine
runs at idle speed (see table).
Release governor arm. Place
Engine Control switch in Run/Idle
position.
6
Carburetor Stop
With solenoid energized, slide sole-
noid until idle speed screw just
touches carburetor stop. Tighten
solenoid mounting screws.
7
Governor Arm Extension
Check for smooth operation, and
readjust
solenoid
position
necessary.
Weld/Power Speed Adjustment
Place Engine Control switch in Run
position.
8
Weld/Power Speed Rod
9
Locking Nut
Loosen nut.
10 Adjustment Nut
Turn adjustment nut until engine
runs at weld/power speed. Tighten
locking nut.
Y Stop engine.
11 Sensitivity Spring
See engine manual for governor
sensitivity adjustment.
Ref. ST-801 532-B / ST-800 397
if