Burkert 2300 Series Краткое руководство по эксплуатации - Страница 15
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Позиционеры клапанов Burkert 2300 Series. Burkert 2300 Series 19 страниц. Remote-positioner, installation on process valves with internal air flow
Также для Burkert 2300 Series: Руководство по эксплуатации (12 страниц), Дополнительные инструкции (12 страниц)
Печатать страницу
Technical data
8.3.4 Rotating the actuator
The position of the connections can be aligned steplessly by
rotating the actuator through 360°.
Only the entire actuator can be rotated. The control unit
cannot be rotated contrary to the actuator.
NOTE!
Damage to the seat seal or the seat contour!
▶ When rotating the actuator, ensure that the valve is in open
position.
Procedure:
→ Clamp the valve body in a holding device (applies only to
valves which have not yet been installed).
→ Control function A:
Without unit control: pressurize the pilot air port 1 with com-
pressed air (5 bar): valve opens.
With unit control: open the valve according to the operating
instructions for the control unit.
→ Counter on the flats of the nipple with a suitable open-end
wrench.
WARNING!
Risk of injury from discharge of medium and pressure!
If the direction of rotation is wrong, the body interface may become
detached.
▶ Rotate the actuator module in the specified direction only ("Fig.
7")!
Typ 2300
→ Place suitable open-end wrench on the hexagon of the
actuator.
→ Rotate counter-clockwise (as seen from below) to bring the
actuator into the required position.
Fig. 7:
Rotating with open-end wrench
8.4
Pneumatic connection
DANGER!
Danger – high pressure in the equipment!
▶ Before loosening the lines and valves, turn off the pressure
and vent the lines.
WARNING!
For control function I – Danger if pilot pressure fails!
For control function I control and resetting occur pneumatically.
If the pressure fails, no defined position is reached.
▶ To ensure a controlled restart, first pressurize the device with
pilot pressure, then switch on the medium.
english
Open-end wrench
15