Miller XT30 Руководство пользователя - Страница 18
Просмотреть онлайн или скачать pdf Руководство пользователя для Сварочная система Miller XT30. Miller XT30 40 страниц. Air plasma cutting and gouging
Также для Miller XT30: Руководство пользователя (44 страниц)
Печатать страницу
5-1. Selecting A Location
Location
18 in.
(460 mm)
5-2. Connecting Gas/Air Supply
Tools Needed:
9/16 in.
OM-253 555 Page 14
.
A complete Parts List is available at www.MillerWelds.com
SECTION 5 − INSTALLATION
!
Do not move or operate
unit where it could tip.
1
18 in.
(460 mm)
1
2
3
From Gas/Air
Supply
1
Line Disconnect Device
Locate unit near correct input
power supply.
Locate unit at least 18 in. (460 mm)
away from a wall or other
obstruction to allow adequate
clearance for cooling air flow.
!
Special installation may be
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
Section 20.
loc_2 3/96 - Ref. ST-151 556 / Ref. 804 503-A
.
Use only clean, dry air with 90
to 120 psi (621 to 827 kPa)
pressure.
1
Gas/Air Inlet Opening
2
Hose
3
Teflon Tape
Obtain hose with 1/4 NPT right-
hand thread fitting. Wrap threads
with teflon tape (optional) or apply
pipe sealant, and install fitting in
opening. Route hose to gas/air
supply.
Ref. 251 808-A