Miller XT30C Руководство пользователя - Страница 16

Просмотреть онлайн или скачать pdf Руководство пользователя для Сварочная система Miller XT30C. Miller XT30C 40 страниц.
Также для Miller XT30C: Руководство (40 страниц)

Печатать страницу

General

Operating Temperature

IP Code − Degree of protection provided by enclosure

Toppling or tilting

Torch −

The XT30C torch is intended for handheld use only. The torch conforms to IEC 60974-7 when used with the Spectrum 375.

Do not use this torch in combination with any other machines.

Gas Type

Gas Quality

Gas Inlet Flow and Pressure

Gas Filtering

Mild Steel capacities (see Section 5-2 for cutting speeds vs material type and thickness)

Cooling Method

Duty Cycle of Torch

Rating of Electrical Controls (Trigger)

Rating of Electrical Controls (Cup)

Approved Systems

Trigger Protection

Safety Devices

Rated Capacity (edge start)

Sever Cut Capacity (edge start)

Pierce Capacity

*Travel speeds are approximately 80% of maximum.

Dimensions

Plasma Cutter Weight

Requirements for the torch connection

Use only compressed air which is free from dirt, oil, and water.

Ensure that the connections are properly assigned and tightened.

For torch replacement, see Miller torch manual Part No. OM-1593

Ensure correct air pressure (flow pressure) and airflow (volume) are set. Insufficient airflow can lead to the torch overheating.

If the unit is operated from a 30* ampere, 115 volt circuit or a 15** ampere, 230 volt circuit, a different input power plug must be installed on the

power cord. See Section 4-11 for instructions.

*A 30 ampere branch circuit is recommended for maximum performance. Performance on a 20 ampere branch service may be limited due to the circuit

breaker or line fuse. Reducing unit output amperage will minimize circuit breaker tripping or blowing a line fuse.

**A 15 ampere branch circuit is recommended for maximum performance. Performance on a 10 ampere branch service may be limited due to the circuit

breaker or line fuse. Reducing unit output amperage will minimize circuit breaker tripping or blowing a line fuse.

OM-255 590 Page 12

A complete Parts List is available at www.MillerWelds.com

5° to 104° F (−15° to 40° C)

IP − International Protection

2 − No ingress of foreign objects

≥

12.5 mm (0.5 in.)

3 − No harmful ingress spraying

C − AC line circuits protected

against ingress of tool . 2.5 mm

dia x 100 mm long (0.1 in. x 4 in.)

S − Fan stationary during water

Up to 15° incline

Clean, moisture−free,

5.0 SCFM (142 L/min)

Particulates to 5 microns

100% at 30 Amps

30 VDC at .1 Amps

30 VDC at 1 Amp

Spectrum 375 w/XT30C torch

Safety trigger guard

Safety interlock devices shut

down power source

3/8 in. at 15 ipm (457 mm/min)*

13-1/8 in. (333 mm) L

5-1/2 in. (140 mm) W

9 in. (229 mm) H

55 lb (25 kg) including torch

IP23CS

water

test

Air or Nitrogen

oil−free

90 PSI (621 kPa)

Air

5/8 in.

3/16 in.

−−

120 PSI (827 kPa)

Min

Max

−−

− −

−−

− −