Miller ArcStation 60SX Руководство пользователя - Страница 13
Просмотреть онлайн или скачать pdf Руководство пользователя для Сварочные принадлежности Miller ArcStation 60SX. Miller ArcStation 60SX 16 страниц.
Печатать страницу
H. Installing Stiffener Brackets And Work Lead Tab
3
DD
Tools Needed:
hex bit 3/16 in.
I.
Grounding The Welding Table
Rear
2
2
Top View
EE and ZZ
1
EE and ZZ
1/2 in.
2
EE and ZZ
2
1
Tools Needed:
hex bit 3/16 in.
1
Stiffener Brackets
Use three bolts EE and three
locknuts ZZ and install two cross
members to rear of center and end
subframes.
2
Tapped Holes For Work Lead
Tab
3
Work Lead Tab
Attach work lead tab with one bolt
DD to bottom side and at the rear of
the tops using any one of the four
tapped holes.
2
4
Leveling Foot (6)
.
To level the 60SX, adjust
leveling feet for the center
subframe first. Then adjust
leveling feet for the end
subframes.
Adjust leveling feet until the welding
table is stable and the tops are
level. Do not tighten jam nuts on
feet at this time.
After setting the welding table in
1
place, make final adjustments to
leveling feet keeping the tops level
and the feet solid on the floor.
Tighten jam nuts on feet at this time.
4
!
Connect welding table to a
good
electrical
(independent of the welding
leads)
unless
a
person assures it is safe to
work
on
an ungrounded
workpiece.
1
Ground Bolt
2
Tapped Hole For Ground Bolt
Use the supplied ground bolt to
connect the welding table to a good
electrical ground according to
national, state, and local codes.
OM-244997 Page 9
ground
qualified