Miller D-74S Руководство пользователя - Страница 24

Просмотреть онлайн или скачать pdf Руководство пользователя для Сварочные принадлежности Miller D-74S. Miller D-74S 36 страниц. Control box

6-4. Trigger Hold Switch

OM-252717 Page 20

Trigger Hold Switches

Trigger hold allows the operator to

weld without holding the gun trigger.

• To use the trigger hold function,

place the trigger hold switch in

the On position.

• The operator must hold the trig-

ger for a minimum of 2 seconds,

but not longer than 6 seconds be-

fore releasing it. Welding will con-

tinue when the trigger is re-

leased.

• To stop welding, press the trigger

again.

Voltmeter

Displays actual or preset voltage

from welding power source through

the 14−pin control cable.

Wire Speed Meter

Displays preset and actual wire

feed speed while welding.

Factory set to display inches per

minute. If display of meters per min-

ute is desired, see Section 5-6.

Voltage Controls

Use controls to adjust voltage out-

put of welding power source.

You can adjust the preset volt-

age display on the wire feeder

to match your power source's

display by adjusting P2 on mo-

tor control board PC101 (left

side), and/or P2 on motor con-

trol board PC1 (right side).

Ref. 803 184

Ref. 803 183