AquaOne CPF 50000 Руководство по эксплуатации - Страница 16
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Системы фильтрации воды AquaOne CPF 50000. AquaOne CPF 50000 19 страниц. Pond pressure filter
Печатать страницуWashing the filter sponges
Suspended matter and dirt are deposited in the filter sponges over time.
These deposits reduce the effectiveness of the filter, so the filter sponges
should be cleaned regularly, e.g. Every week.
The filter sponges should be cleaned when cloudy or even dirty water flows
out of the water outlet and back into the pond.(When the red indicators which
in the handle function is float on.)
1. Turn clockwise until it clicks into the "clean" position.
2. Circumgyrate cleaning handle hard and several times. This squeezes
the filter sponges and cleans them mechanically. Circumgyrate for
deasil and at will achieve a better results.
3. The filter now will be rinsed .Once clean water could be seen through
the transparent spiral stepped hose adapter at the cleaning connection,
turn anti-clockwise until it clicks into the "filter"position.
4. The filter is now operating again. Check the water flow into the pond.
Replacement of the filter sponges
lt the water flow is too small due to dirty filter sponges and can not be
improved through cleaning with the handle function. The filter sponges must
be washed or replaced.
Please do not use any chemical cleaning agents so as not to kill oft the
microorganisms in the filter sponges.
1. Disconnect the mains plug of the filter.
2. Switch oft the pump and ensure that it cannot be switched on
unintentionally, remove all hoses by unscrewing the union nuts.
3. Remove protective buckle, then open the clamp.
4. Lift offthe lid with the filter sponge assembly. Place the lid upside down
on another clean surface. The filter sponges are lying with filter plat
facing up.
5. Remove the diversion pipe anticlockwise,remove the screws on the
gear and the separate plate.
6. Remove the filter sponges to replace or clean.
7. Pull oft the filter sponges part and clean them under flowing water. Give
the filter sponges a good squeeze.
8. Clean the container, filter sponges,0-ring and the edge of the container
by spraying them with a water hose.
9. Put the sponge part as follow,put on the separate plate,fixed cleanness
gear set, fasten the diversion pipe.
10. Place the 0-ring 3 onto the upper edge of the container.(ln order to
easy to fit you should make it wet).press down on the lid.
11. Put the clamp on the right place,pull on the pull-tab ,finally push the
safety latch in.
By Aquaristikwelt24
www.aquaristikwelt24.de
16 |
S e i t e