Diamond 393265 Руководство - Страница 6

Просмотреть онлайн или скачать pdf Руководство для Торговое пищевое оборудование Diamond 393265. Diamond 393265 11 страниц.

Печатать страницу

• Leave an adequate space between the appliance and any

side walls in order to enable subsequent servicing or

maintenance operations.

• Check and if necessary level the appliance after

positioning. Incorrect levelling can cause appliance

malfunctioning.

3.1. JOINING APPLIANCES

• (Fig.1A) Undo the 4 fixing screws and remove the control

panels of the appliances.

• (Fig.1B) Remove the fixing screw nearest the control

panel, from each side to be joined.

• (Fig.1D) Bring the appliances together and level them by

turning the feet until the tops match.

• (Fig.1C) Turn one of the two plates inside the appliances

180º.

• (Fig.1E) From inside the control panel of the same

appliance, join them at the front side, screwing one M5x40

Hex Head screw (supplied) on the opposite insert.

3.2. FLOOR FIXING

To avoid accidental tipping of built-in half-module appliances

installed separately, fix them to the floor carefully following

the instructions enclosed with the corresponding accessory

(F206136).

3.3 INSTALLATION ON BRIDGE, CANTILEVER

FRAME OR CEMENT PLINTH

Carefully follow the instr uctions enclosed with the

corresponding accessory. Follow the instructions enclosed

with the optional product chosen.

3.4 SEALING GAPS BETWEEN APPLIANCES

Follow the instructions enclosed with the optional sealing

paste pack.

4. FUME EXHAUST

4.1 TYPE "A1" APPLIANCES

Position type "A1" appliances under an extraction hood to

ensure removal of fumes and steam produced by cooking.

4.2 TYPE "B" APPLIANCES

(in conformity with the definition given in the Installation

Technical Regulations DIN-DVGW G634: 1998)

Whenever the appliance dataplate specifies only type Axx,

such appliances are not designed for being directly connected

to a flue or fume exhaust pipe run to the outside. However,

the same appliance can be installed under an extractor hood

or similar forced extraction system for fumes.

4.2.1 CONNECTION FLUE

• Remove the grille from the fume exhaust.

• Install the connection flue, following the instructions

supplied with the accessory (optional).

4.2.2 INSTALLATION UNDER AN EXTRACTOR

HOOD

• Place the appliance under the

extractor hood (fig. opposite).

• Raise the fume exhaust pipe without

altering the section.

• Do not install dampers.

• The correct height of the exhaust

pipe and the relative distance from

the extraction hood must comply

with current standards.

• The end of the exhaust pipe must be

at least 1.8 m from the support

surface of the appliance.

Note! The system must ensure that: a)

the fume exhaust is not obstructed; b) the length of the

exhaust pipe does not exceed 3 m. Use the adapter for

connecting fume ducts of different diameters.