Aquaport AQP-16AO Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для Системы фильтрации воды Aquaport AQP-16AO. Aquaport AQP-16AO 12 страниц.

uSing the polaClear to filter Water

Warning: Do not use with water that is microbiologically unsafe or of unknown quality

without adequate disinfection before or after the system.

Step 1:

Before plugging unit in, thoroughly wash all removable parts (except filter cartridge) with warm

water and detergent before use. Rinse thoroughly.

Step 2:

Wash out the water cooler by filling the tank with water and flushing the water through the taps.

Repeat this process if necessary.

Step :

Put filter bottle together as shown on page (5). Make sure Filter bottle ring is placed on the unit,

and sit the filter bottle on top.

Step :

Prepare the filter cartridge as per Filter Replacement instructions on page (8). Push filter cartridge

firmly in place.

Step 5:

Pour 1-1.5L/ 34-52oz of water into unpurified water tank. Allow water to filter through to the

purified water tank and to chill reservoir tank within unit.

note: First filtration will take longer than subsequent.

Step :

Add a further 1-1.5L/ 34- 52oz of water to completely fill the filter bottle. Do not exceed the

indicator fill lines.

Step 7:

Discard water from first fill through taps.

Step 8:

Repeat steps 5 & 6.

Step 9:

Place lid on top and set filter change dial to indicate the month of your installation. This device will

then indicate at 'Replace' mark the recommended month in which you should replace the filter

cartridge. We recommend changing the filter approximately every 2 months or after dispensing

150L / 40gallons of water.

Step 10:

Plug in unit, turn on rear power switch. Allow unit to cool water then use.

note: Once water has been chilled unit will go into a low power mode and chilled light will dim.