AquaPRO 02AP008B Инструкции - Страница 3

Просмотреть онлайн или скачать pdf Инструкции для Водяной насос AquaPRO 02AP008B. AquaPRO 02AP008B 4 страницы. Water feature pump

Печатать страницу

MAINTENANCE

DISCONNECT POWER CORD FROM THE POWER SUPPLY BEFORE PERFORMING

MAINTENANCE. NEVER LIFT THE PUMP BY THE POWER CORD.

• All AQUAPRO submersible pumps are water

cooled; if pump becomes restricted it will overheat

and could cause permanent damage. Ensure pump

does not become blocked or restricted.

• The power cord cannot be replaced,

if the cord is damaged, the pump must

be discarded.

• The impellor set is a wearing consumable part.

Regular inspections, cleaning and maintenance of

impellor is necessary to ensure longer impellor life.

• If the impellor set becomes worn or damaged it

should be replaced (available from your dealer or

special orders). Failure to do so may cause serious

damage to pump.

PART DESCRIPTION

1. FRONT CAGE 2. BIO-SPONGE 3. FLOW CONTROLLER

4. IMPELLOR COVER 5. O RING 6. IMPELLOR 7. MOTOR

NOTE:

PLEASE CONSULT YOUR RETAILER FOR QUALITY ORIGINAL

AQUAPRO REPLACEMENT PARTS FOR YOUR AQUAPRO PRODUCT.

VISIT WWW.AQUAPROONLINE.COM.AU FOR NEAREST STOCKISTS.

[email protected]

AQUAPRO AP1050/AP3000 Instructions.indd 3

AP1050 / AP3000 PUMP

WWW.AQUAPROONLINE.COM.AU

WEB

I N S T R U C T I O N S

1. Disconnect the power cord from the power supply

before performing maintenance.

2. Remove the pump from water, detach tubing/

fountain kit and remove front cage from pump.

3. Remove the impellor locking ring/ cover by either

turning anti-clockwise and pulling out.

4. Gently remove the impellor and shaft, use long nose

pliers if needed. Take care not to break ceramic shaft

(if applicable) because they are brittle.

5. Clean impellor, checking for any signs of wear or

damage.

6. Reinstall the shaft, and then carefully slide the

impellor onto the shaft. The impellor will pull itself in

by magnetic force, this is normal. (Take care not to

pinch your fingers).

7. Replace the impellor cover making sure the shaft is

located properly on the impellor cover.

8. Replace the front cage.

9. Re-attach tubing/fountain kit, submerse in water,

connect to power supply and turn on.

22/9/21 1:54 pm