Diamond Diverso PSF 400 G Инструкции по эксплуатации и установке - Страница 5

Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и установке для Торговое пищевое оборудование Diamond Diverso PSF 400 G. Diamond Diverso PSF 400 G 14 страниц. Cast iron griddle plates

Печатать страницу

While cooking, the temperature can be regulated using the control knob (n°1 on picture)

from high flame to low flame in order to avoid over-cooking.

A safety thermocouple cuts the gas supply if the burner is extinguished. The low flame

of the appliance is pre-adjusted in the factory, it must not be changed. This extinction

can mainly occur when there is a lot of wind. In this particular case, just repeat the

switching-on procedures described on previous page.

Your appliance is equipped with a removable collector tray (n° 5 on picture) to drain

juice and fats. It must be emptied regularly. It is recommended to pour a little water in

the tray when you start cooking to facilitate maintenance and to avoid the solidification

and accumulation of fats at the bottom of the tray.

Never use the appliance without the drip tray (n°5 on picture).

5. FUNCTIONING / HANDLING

a) Installation/Assembly:

- Unpack carefully the machine from its packaging.

- Place the griddle plate on a plane and heatproof surface.

- Never place the device near a wall or near a partition makes of combustible materials

even if it is very well isolated.

- A distance of minimum 10 cm with the partition or the wall is necessary.

- Remove the protective film around the machine.

b) First starting:

Before the first use, remove the anti-corrosion protection fat with a cleaner. Then, it is

necessary to grease plates with oil.

During the first use, warm your machine up outside during about 30 min to evacuate

residual smokes of manufacturing oil from the metallic parts. This may emit a slight

smell for a few moments.

First cleaning

Clean the device before the first use. (See 6 Cleaning)

Gas connection

The appliances run on the following gases: Butane G30, Propane G31, Natural gas

G20/G25. The appliances are originally delivered with Butane/Propane injectors corre-

sponding to the category II2E+3+. The connection is made thanks to a thread 1/2.