Burley 160 Руководство по установке и эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Крытый камин Burley 160. Burley 160 8 страниц.

Hot air vent

Thermostat knob

Slots for cable

Socket to plug lead in

Unpacking and installing the appliance

Open the packaging carefully and remove the appliance. Keep the original packaging for future transport.

The mains cable, plugs into the socket on the under-side of the appliance. Never use an extension lead. Take the

mains cable through one of the cut outs at the sides or rear, ensuring that it is not trapped. The mains cable must

remain at the back of the appliance and must not be in contact with any hot

elements.

Securing the appliance

For stability you must fix the fire into position using the fixing kit, this is to ensure

that the appliance will not fall forward. It is not usually necessary to have the wire

taut.

Using the wall plug, attach the eye-bolt to the wall or the back of the fireplace

behind the fire. Slacken the upper screw (with the washer on it) on the side of the

fire – see diagram. Wrap one end of the wire half way around the screw and

tighten so the wire is trapped between the washer and the chassis. Now pass the

other end of the wire through the eye bolt. Thread the wire through one of the two

fixing holes in the other side of the chassis, position the fire then pull the wire

through to take up the slack. Screw the screw and washer into the other hole,

wrap the wire around it, then tighten to trap it. Check the fixing by tipping the fire

forwards and giving it a small tug to ensure that it is secured.

To operate the appliance

Plug the appliance into the socket.

Press the power switch behind the ashpan. The fire will not operate if this is off.

To turn the glow on, press the right hand button on the remote handset. For the remote control to operate it should

be within 3 meters of the appliance and directly in front.

To turn the flame effect on with the glow, press the right remote button again.

To turn the heater on with the glow and the flame, turn the thermostat knob clockwise to maximum, then press the

right remote button again.

Pressing the left hand 'off' button will turn the appliance off from any setting.

Thermostat. The thermostat automatically turns the heater on and off according to room temperature. To set it,

leave it fully on, and when the room reaches the desired temperature, slowly turn it anti-clockwise until the heater

clicks off. It will then maintain this temperature by modulating on and off as the room cools and warms. The

thermostat turns the heater completely on or off you do not get 70% of the heat on number 7 and 30% on number 3.