AquaPur H3HNC Руководство по эксплуатации - Страница 7

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Диспенсер AquaPur H3HNC. AquaPur H3HNC 10 страниц. Water dispencer

General information

To ensure proper operation, please read this manual carefully.

Providing hot,normal& cold water. The devices are compressor refrigeration

series. It is low energy consumption.

Quick-refrigerating and low noise. The products are made of high quality raw

material: the hot water tank and heating tube are made of stainless steel.

Note: Do not connect the electrical power plug until water comes out of the hot

water tap.

1) Position the water dispenser out of direct sunlight and away from heat and

excessively damp place, leave an adequate open space (10cm to 20cm) behand

the water dispenser for good ventilation.Do not position the water dispenser close

to expensive furniture or other electrical household appliances, as water spill can

cause serious problems.

2) When carrying it,the angle of inclination should be less than 45 degree.

3) Neither modify the power plug nor use an extensive cord,overheat or a fire could

result.

4) Do not start or stop the heating or refrigerating process by plugging or unplugging

the power cord.

5) Keep the water dispenser beyond the reach of children to avoid scald.

6) Cleaning the water dispenser regularly with soft cloth. Do not wash the cabinet

with water. Do not wash the cabinet with gas or chemical medication as it can

damage the cabinet.

7) The water tank should be sterilized periodically. The water and electricity supply to

the dispenser is shut off. Unscrew the screws (14) and lift the cover. Empty water

tanks through water drain(9). Fill the cold water tank with disinfectant solution and

wait about 30 minutes. Then empty the tank and open valve for water supply. After

the tanks are washed with fresh water, place the stopper and thread the drain plug

cap into the drain. Put the stopper and thread the cover of water drain. Connect

the dispenser to the power supply.

WARNING:

- Do not damage the refrigerant circuit.

- If the supply cord is damaged, it must be replaced by manufacturer, its service

agent or similarly qualified persons in order to avoid hazard.

1) Connect to the water source supply (13). Press the hot water tap until water flows

out. Let flow 3-5 liters of water

2) Plug the power cord to the wall outlet. Switch the heating and refrigerating

switches on, then the heating and refrigerating processes start to work.