Aquarea PAW-TG20C1E3STD Руководство - Страница 11

Просмотреть онлайн или скачать pdf Руководство для Водонагреватель Aquarea PAW-TG20C1E3STD. Aquarea PAW-TG20C1E3STD 19 страниц.

WARNINGS

The appliance may be used by children aged 8 and older and persons with physical, sensory or mental

disabilities or lacking experience or knowledge, if they are under supervision or taught about safe use of the

appliance and if they are aware of the potential dangers.

Children should not play with the appliance.

Children should not clean or maintain the appliance without supervision

The installation should be performed in accordance with the valid regulations and the instructions of the

manufacturer. It should be performed by a professionally trained installation expert.

It is obligatory to install a safety valve with a rated pressure of 0.6 MPa (6 bar), 0.9 MPa (9 bar) or 1.0 MPa (10

bar) – see the label - on the inlet pipe of the hot water storage tank to prevent the elevation of pressure in the

tank by more than 0.1 MPa (1 bar) above the rated pressure.

Water may drip from the outlet opening of the safety valve, so the outlet opening should be set to atmospheric

pressure.

The outlet of the safety valve should be installed facing downwards and in a non-freezing area.

To ensure proper functioning of the safety valve, the user should perform regular controls to remove limescale

and make sure the safety valve is not blocked.

Do not install a stop valve between the hot water storage tank and the safety valve, because it will impair the

pressure protection of the storage tank!

Before connecting the heater to the power supply, the storage tank must be filled with water!

The storage tank is protected in case of failure of the operating thermostat with an additional thermal cut-out.

In case of thermostat failure water in the storage tank may reach the temperature of up to 130°C in accordance

with safety standards. The possibility of such temperature overload should be taken into consideration in the

execution of plumbing.

Should you choose to disconnect the power, the storage tank should be drained thoroughly before the onset of

freezing conditions.

Water from the storage tank is drained through the inlet pipe of the tank. For this purpose, a special fitting

(T-fitting) with an outlet valve must be mounted between the safety valve and the inlet pipe.

Please do not try to fix any defects of the storage tank on your own. Call the nearest authorised service provider.

Our products incorporate components that are both environmentally safe and harmless to health, so they can

be disassembled as easily as possible and recycled once they reach their final life stage.

Recycling of materials reduces the quantity of waste and the need for production of raw materials (e.g. metals)

which requires a substantial amount of energy and causes release of harmful substances. Recycling procedures

reduce the consumption of natural resources, as the waste parts made of plastic and metal can be returned to

various production processes.

For more information on waste disposal, please visit your waste collection centre or the store where the

product was purchased