Burmester 032 Руководство пользователя - Страница 14

Просмотреть онлайн или скачать pdf Руководство пользователя для Усилитель Burmester 032. Burmester 032 16 страниц. Integrated amplifier

Operating temperature An operating temperature that is too high or too low may cause malfunctioning. We

therefore recommend letting the 032 sit for a while after unpacking and before connecting

and operating it.

The pins of the connecting terminals on the back panel should not be touched by fingers

Terminals

under any circumstances. Static discharges may damage the electronic circuitry inside the

unit.

The IR receiver (1) receives signals from the BURMESTER remote control and must not be

IR receiver

covered up by objects.

Be careful when touching the housing – it may get quite warm during operation.

Heat development

If the unit does not react when pressing the control keys on the front it may be reset to

Reset

normal operation by switching it off and back on using the AC mains switch in the back.

During the summer months, malfunctions often occur due to voltage spikes in the power

Lightening strikes

lines after lightning strikes. Completely unplugging the power cord offers the only effective

protection. Merely switching the 032 off does not suffice since voltage spikes are able to arc

over separated contacts.

We supply custom-made balanced as well as unbalanced interconnect cables and speaker

Interconnects

cables of any length to ensure highest-quality signal paths for our components. The

impedance of our cables is ideally matched to all BURMESTER components.

For the cleanest power supply we recommend our triple-shielded power cord BURMESTER-

POWER.

The fuses are located inside the unit and should be changed only by a qualified technician.

Fuses

Check before operating the 032 to see if the voltage setting shown on the back panel below

Voltage

the AC mains input conforms to voltage of your household power supply. Any change

should only be done by an expert.

We offer warranty for this unit provided the 032 has been hooked-up and operated

Warranty

correctly, is mechanically undamaged.

Opening the unit, modifying it or dismantling outlets will void the warranty.

Never clean the housing with a wet cloth or chemical cleaning agent. Always make sure that

Care

no liquid gets into the housing.

CAUTION

Before opening the housing or changing the fuses always unplug the unit from the

wall outlet. DANGER OF ELECTRIC SHOCK!

GENERAL INSTRUCTIONS