Aquasana OptimH2O AQ-RO-BASE Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для Система водоснабжения Aquasana OptimH2O AQ-RO-BASE. Aquasana OptimH2O AQ-RO-BASE 9 страниц. Drinking water system reverse osmosis filtration technology

Печатать страницу

7 — STEP 1–3 FILTER INSTALLATION

Before you begin: make sure the cold water valve is shut off and there is no pressure in the system. Carbon

(red) filter cartridges will come pre-installed in their cartridge sumps.

1 Attach red carbon sump to the 1st stage position on the inlet side of the system manifold.

Make sure all connection points are aligned and push the top of the sump up and into the

system manifold. Turn it towards the right until it locks in.

2 Repeat step 1 for the 2nd Stage RO membrane that goes in the center, and for remaining

carbon cartridge in the 3rd stage position on the outlet side of the system manifold.

8 — SANITIZE, TEST & PURGE

Sanitize

Note: Sanitization is recommended immediately after RO Filter System installation and any inner-part

servicing. The person sanitizing should have clean hands during this process.

1 Shut off water supply to RO system.

2 Open faucet. If tank is not empty, allow to

drain until empty.

3 With included eyedropper and household

bleach (5.25%), disconnect white tubing

from the manifold outlet labeled "TANK".

Note: Bleach needs to be handled

according to manufacturer's instructions.

4 Add 3ml bleach into open end of tank white

tubing.

5 Reconnect the tank from the tube into the

manifold outlet labeled "TANK". Be sure to

push tubing in all the way.

6 Sanitation will be completed during the following pressure test and purge. Important:

Bleach must be completely removed from system before drinking water. See Purge

instructions below.

Pressure Test

Important: Complete sanitization prior to pressure test.

1 Open cold water supply valve to RO Filter System.

2 To purge air from the plumbing system, open kitchen faucet. Close faucet when water runs

smooth.

3 Confirm RO faucet is closed.

4 Within approximately 2 hours, pressure will start to build in the RO Filter System. Carefully

inspect all connections and fittings while this pressure buildup occurs.

5 Check for leaks. If leaks are found, fix by ensuring all tubing is cut squarely and fully inserted.

Also confirm there are no scratches, dents or notches at tubing end. If there are, squarely cut

1" off and re-insert.

Note: When RO Filter System is first pressurized, water may project

from faucet air gap hole until air is passed from RO Filter System.

Purge

1 Open RO faucet and let water flow through system for 24 hours.

Note: Flow rate will be slow during this time.

2 Close RO faucet after purge is complete.

Note: Your RO Filter System is ready for use when purge is complete, however, you will not have filtered

water immediately. It takes 1-3 hours to completely fill the tank. The flow rate will be less than your

kitchen faucet. Water will run to the drain while the RO Filter System is filtering water – even when not in

use. This is normal. Water going to drain will stop automatically when tank is at capacity.

Stage

RO Membrane

OptimH2O™

AQ-RO3-RO

OptimH2O™