AquaScape MicroPondless Инструкции по установке и руководство пользователя - Страница 8

Просмотреть онлайн или скачать pdf Инструкции по установке и руководство пользователя для Открытый фонтан AquaScape MicroPondless. AquaScape MicroPondless 20 страниц.

Печатать страницу

Installing the MicroSkim

• Cut the inner box using a pair of

scissors, and insert the skimmer

faceplate into the hole.

(See fig. 20)

• Make sure MicroSkim

faceplate

is in the upright position.

(See fig. 21)

• Temporarily install the faceplate

and liner to the skimmer using

two screws in the upper corners.

Using an awl or nail poke the

first hole in the liner all the way

through to the inside of the filter

box. Be careful not to dam-

age the threads on the nut

inserts when punching the

holes with the awl! Remove

the awl or nail while holding the

faceplate and liner in place and

Fig. 21 Skimmer faceplate is

properly placed when hinge is on the

bottom.

STEP 8

Add rock and gravel

Rocking in the

Pondless

Waterfall

• Add 1 ½" to 2" size gravel into the

basin up to the side of the basin.

(See fig. 25)

• A finishing layer of decorative

gravel can be added to the top

if desired.

cont...

begin threading one of the

screws into filter. Repeat this

process for the other screw.

(See fig. 22)

• Now remove the faceplate from

the skimmer, keeping the screws

installed through the faceplate

and liner.

• Apply a bead of fish-safe silicone

sealant around the skimmer

opening, over the nut inserts.

Pre-installing the two screws in

the earlier steps will make it easy

to line up the skimmer faceplate

after the silicone is applied and

will keep the silicone in as thick

of a bead as possible.

(See fig. 23)

Fig. 22 Using an awl, poke holes

through the liner at screw holes; tem-

porarily screw top corners into place.

• Set larger boulders (6" – 18")

around the perimeter to sup-

port the edges of the basin. The

plumbing from the MicroFalls

filter should be brought over

a slightly lowered edge of the

liner and to the location of the

MicroPondless

Vault. Boulders

and gravel can be used to hide

the plumbing. (See fig. 26)

• Replace the skimmer faceplate

and the two corner screws, and

then proceed with the bottom two

corners (See fig. 24). Make sure

the holes in the faceplate that

the weir flap clicks into are on

the bottom.

• With the 4 corners secured, you

may now punch the remaining

holes with your awl and thread in

all the screws. Again, be careful

not to damage the threads on the

nut inserts.

• Let dry for at least one hour before

introducing water!

Note: Power tools are not recom-

mended for installing the screws

and may strip the nut inserts.

Fig. 23 After alignment remove face-

plate and apply silicone sealant.

Fig. 25 Add gravel into the basin.

Fig. 19 Mark the skimmer opening

on liner and cut an area 1.5" inside

that mark.

Fig. 20 Place skimmer faceplate

through liner and place into

skimmer for alignment.

Fig. 24 Carefully replace the

skimmer faceplate into the silicone

lined opening.

Fig. 26 Placement of MicroSnorkel

Vault and MicroCentipede

Module

™

within basin.

™