AquaScape AQUAFORCE 5200 Инструкции и обслуживание - Страница 7

Просмотреть онлайн или скачать pdf Инструкции и обслуживание для Насосы для пруда AquaScape AQUAFORCE 5200. AquaScape AQUAFORCE 5200 16 страниц. Solids-handling pond pump
Также для AquaScape AQUAFORCE 5200: Инструкции и руководства по обслуживанию (16 страниц), Руководство по эксплуатации (16 страниц)

• Remove the screws

securing the pump

restraining bracket,

allowing the pump to be

lifted from the lower cage.

• For easier pump access, pull the power cord free from the

strain relief.

• Remove the four screws that hold the water cover

chamber and inspect the impeller rotor assembly.

• If your rotor assembly impeller and internal pump body

have excessive scale build-up, clean with a mild acid,

such as white vinegar or non-abrasive calcium, lime and

rust remover product. A sponge or soft-bristled brush that

won't scratch the stainless steel can be used at this time.

Removing scale build-up will allow your pump to run like

new again.

Replacing the Impeller/Rotor Assembly

• For Model 3600 & 5200:

When replacing the

AquaForce

3600 or 5200

rotor-impeller assembly

into the pump chamber,

note the proper orientation.

The raised key on the

impeller face plate should

be lined up with the groove

in the pump housing.

• For Models 1000, 1800 and 2700: The 1000, 1800 and

the 2700 models allow the impeller-rotor assembly to be

inserted into the pump body with no special alignment

guides needed.

PUMP FLANGE PIN

• AquaForce® 5200 ready for reassembly: The water

chamber cover will only ﬁ t back onto the pump with the

top of the tear-drop shapes lining up, along with matching

the hole in the cover with the pin on the face of the pump

motor ﬂ ange.

PUMP

FLANGE PIN

GROOVE

RAISED KEY

PUMP WATER

COVER HOLE

PUMP WATER

COVER HOLE