Panasonic WV-SP508 Руководство по установке - Страница 27
Просмотреть онлайн или скачать pdf Руководство по установке для Видеокамера Panasonic WV-SP508. Panasonic WV-SP508 40 страниц. Ip video cameras
Также для Panasonic WV-SP508: Технические характеристики (2 страниц), Руководство по установке (36 страниц), Примечание по интеграции (8 страниц)
Печатать страницу
n
Connect the power supply.
IMPORTANT:
• The 12 V DC power supply shall be insulated from the commercial AC power.
• The operating sound might be heard when the power is turned on, however it does not indi-
cate any malfunction.
When using 12 V DC power supply*
q Loosen the screw of the power cord plug (accessory).
w Connect the cable of the 12 V DC power supply* to the
power cord plug.
Strip 3 mm to 7 mm {1/8 inches to 9/32 inches} from the
end of the wire, and twist the stripped part of the wire
sufficiently to avoid short circuit.
Specification of cable (wire): 16 AWG - 24 AWG
• Check whether the stripped part of the wire is not
exposed and is securely connected.
e Tighten the screw of the power cord plug.
r Connect the power cord plug to the 12 V DC power sup-
ply terminal on the rear of the camera.
* FOR UL LISTED MODEL(S), ONLY CONNECT 12 V DC
CLASS 2 POWER SUPPLY.
IMPORTANT:
• Be sure to use the power cord plug provided with this product.
• Be sure to fully insert the power cord plug into the 12 V DC power supply terminal. Otherwise,
it may damage the camera or cause malfunction.
• When installing the camera, make sure that excessive force is not applied to the power cable.
• Be sure to use an AC adaptor compliant with the Specifications regarding power source and
power consumption (
Single core, twisted
page 35).
☞
10BASE T/100BASE-TX
AUDIO OUT
MIC/LINE IN
ACT
LINK
SD CARD/ABF
MONITOR OUT
EXT I/O
GND 4 3 2 1
ALARM IN 1/DAY/NIGHT IN
ALARM IN 3/AUX OUT
ALARM IN 2/ALARM OUT
To 12 V DC
power supply*
(This illustration represents
WV-SP509.)
12 V DC power
cord plug
(accessory)
(GND)
INITIAL
SET
POWER
12V = IN
(12 V DC)
27