Panasonic CT-32G21 Руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для ТЕЛЕВИЗОР Panasonic CT-32G21. Panasonic CT-32G21 36 страниц. Color television
Печатать страницу
Installation
Receiver Location
This unit is intended to be used with an optional stand or entertainment center. L;on_ultyour dealer for available upt=o= =b.
Locate for comfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the
screen.
Use of some types of fluorescent lighting can reduce remote control transmitter range.
Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or
moisture.
To insure optimum color purity do not position magnetic equipment (motors, fans, other speakers, etc.) nearby.
Optional External Equipment Connections
The Video/Audio connections between components can be made with shielded video and audio cables. For best perfor-
mance, video cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or electronic
supply house.
Before you purchase any cables, be sure you know what type of output and input con nectors you r various components
require. Also determine the length of cable you'll need.
AC Power Supply Cord
Remote Control Battery Installation
Batteries: Use two "AA" batteries
1. Turn the Transmitter face down. To remove top cover, press down on
marking and slide cover off in the direction indicated.
2.
Install the batteries as shown in the battery compartment. (Polarity (+) or
(-) must be correct.)
3.
Replace the cover and slide in reverse until the lock snaps.
"
°
:
:
...........
I
h
HelpfulHint:
I
For frequent Remote Control users, replace old
J
batteries with Alkaline batteries for longer life.
I
Precaution
on Battery Use
Incorrect installation can cause battery leakage and corrosion that will
damage the Remote Control Transmitter
Observe the Following Precautions:
1.
Batteries should be replaced as a pair. Always use new batteries when
replacing the old set
2
Do not combine a used battery with a new one
3
Do not mix battery types (Example: "Zinc Carbon" with "Alkaline").
4
Do not attempt to charge, short-circuit, disassemble, heat or burn used
batteries.
5
Battery replacement is necessary when Remote Control
reacts
sporadically or stops operating the Receiver.
Whenever you remove the batteries to replace
them, you may need to reset the Remote
Control Infrared Codes. We recommend that
you initially record the codes on page 29,
when you setup the remote.
Polarized Plug
°,
• "
V
Press Down Here
And Slide Cover
Back
.°
.°
.°
..
J
-5-