Diamond Audio MOTORSPORT MP525 Руководство пользователя - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя для Динамики Diamond Audio MOTORSPORT MP525. Diamond Audio MOTORSPORT MP525 12 страниц. Pro audio horn coax drivers
Печатать страницу
SYSTEM DESIGN - PASSIVE/ACTIVE
TYPICAL "BI-AMPED" SYSTEM USING
PASSIVE CROSSOVERS
The DIAMOND AUDIO MP PRO AUDIO COAX
HORN comes with a special 12dB per octave
crossover. It is HIGHLYrecommended that this
be used at ALLtimes - UNLESS you are using
an active crosssover set at above 7kHz. This
system, shown is "Bi-Amped", but not 'Fully"
active. FRONT channels of this 4 channel
amplifier are driving the mid bass drivers.
REAR channel are driving the tweeters.
The MIDBASS is shown with a 0.1mH inductor
(not included)in series to cross over
the midbass at 6Khz with a 6dB
roll-off. This setup makes it easier
to adjust level of the midbass
versus the tweeter.
(ONLY RIGHT CHANNEL SHOWN)
SYSTEM DESIGN - FULLY ACTIVE
TYPICAL "FULLY ACTIVE" SYSTEM
MP COAX HORN drivers can be "Bi-Amped"
Or what is commonly called FULLY active
system setup. In the system shown - the
tweeter(s) are wired to the FRONT channels
and the MIDBASS driver section is wired to
the rear channels. At this point you should
seriously think about purchasing a DSP
processor - unless your amplifier has a
HP filter that can go to 8Khz Using a
DSP processor makes it much easier
to control and tune your system.
We recommend using the Diamond
Audio BTDSP-46. Small 4 in 6 out,
simple to use....and controlled by your
SmartPhone
BTDSP-46
6
** SPECIAL NOTE**
Tweeter connected "out-of-phase" to be acoustically "in-Phase"
0.1mH Inductor (Low Pass 6KHz)
(Not included)
Front channels
A
U
D
I
O
Rear channels
MSCOAX Woofer Connection
(HP filter at 80Hz at 12dB per octave MINIMUM)
Front channels
Rear channels
(ONLY RIGHT CHANNEL SHOWN)
MSCOAX tweeter
12dB per octave
High-Pass filter
+
(included)
+
"OPTIONAL"
TWEETER ATTENUATION
4 Channel
Amplifier
4 Ohm resistor
INCLUDED
MSCOAX tweeter Connection
(HP filter at 6Khz at 12dB per octave MINIMUM)
4 Channel
Amplifier
A
U
D
I
O
+