Diamond Audio Technology D6 300.4 Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для Автомобильный усилитель Diamond Audio Technology D6 300.4. Diamond Audio Technology D6 300.4 12 страниц. D6 series reference amplifiers

Печатать страницу

Diamond Audio Technology D6 300.4 Руководство пользователя

Turn-on (Remote)

Locate the terminal labeled "REMOTE" between the ground and +12V power connection

points on the end of the amplifier. Your source unit should have a wire in its harness

labeled "REMOTE" or "AMP TURN-ON." Some source units come equipped with a "Power

Antenna" lead only. This should also work. Run this wire from your source unit to the

amplifiers REMOTE connection. Strip approximately 1/2Êinch of insulation from the wire.

Insert the wire into the terminal, and tighten the Allen screw. D6 amplifiers will accept

remote turn-on wire up to 10Êgauge or banana jacks directly.

SPEAKER CONNECTIONS

Diamond Audio recommends using speaker wire of at least 16Êgauge. Lay out the wire in

the vehicle from the individual speaker locations to the amplifier(s). Observe safe wiring

precautions.

D6 Amplifiers will accept speaker wire up to 10Êgauge directly. Locate the speaker

terminal block on the end of the amplifier. Strip approximately 1/2Êinch of insulation

from the wire, insert the wire into the terminal, and tighten the Allen screw. Repeat for all

speaker wires. Please observe recommended minimum speaker impedances to prevent

possible damage.

Banana Jacks can be inserted into the speaker block. Remove the set screw completely

and insert the Banana Jack into the end of the block.

D6 300.4/600.4

Bridging

Both pairs of channels on the D6 4-channel amps are capable of being bridged to a

4ÊOhm mono output. Creation of the mono channel is accomplished by using the left

channel positive (+) output connection of the amplifier for the speaker positive and the

right channel negative (-) output connection of the amplifier for the speaker negative.

Note: It is important that a 4 Ohm minimum total speaker impedance load is observed

when bridging the amp! If an impedance load of less than 4 Ohms is used, you will

eventually damage your amplifier and void your warranty.

RCA

CH 1/2 & 3/4 INPUTS

The RCA cables from your source unit should be inserted here.

AUX. OUTPUT

These RCA outputs are used to provide filtered or unfiltered signals to an outboard

processor or amplifier.

Crossovers

Diamond D6 4-channel amplifiers feature second-order 12dB/octave and fourth-order

24dB/octave Butterworth filters. These filter networks sum to a flat response at their

-3dB break points. This results in a smooth and seamless transition from one frequency

band to the next. Butterworth filters provide maximally flat frequency responses when

compared to other filter structures.