Diamond Audio Technology D7054 Руководство по установке - Страница 9

Просмотреть онлайн или скачать pdf Руководство по установке для Автомобильный усилитель Diamond Audio Technology D7054. Diamond Audio Technology D7054 11 страниц.

Печатать страницу
CONTINUOUS RMS OUTPUT POWER
Note: Full Rated Power is generated at all voltages between 11 and 16VDC.
D7054
50W x 4 @ 4 Ohm Stereo
100W x 4 @ 2 Ohm Stereo
200W x 2 Bridged @ 4 Ohms
(minimum impedance)
CROSSOVER SPECIFICATIONS
Quantity:
3 (1 for CH 1/2 INPUT, 1 for CH 3/4 INPUT,
1 for X-OVER OUT)
Type:
Fully Independent and Selectable Highpass,
Lowpass, Bandpass or All-pass.
Slope:
Third Order 18dB/Octave
Alignment:
Butterworth

FUSE RECOMMENDATIONS

D7 Professional Reference Series Amplifiers, by design, require external fusing.
Research has shown that a circuit board mounted fuse can create a drop in
available DC voltage at the input of the power supply resulting in increased
current draw.
We recommend that you install the correct size fuse/holder combination to the
main power cable within 18 inches of the battery. This will protect your vehicle
from fire damage due to a short circuit to the chassis or vehicle body. If a single
amplifier is installed, follow the fuse recommendation below. If installing
multiple amplifiers, add up the total fuse ratings of all installed amplifiers. This
should be used as your main fuse rating.
Amplifier
D7054
D7104
Note: A main fuse must be installed within 18 inches of the positive
battery terminal.
2
D7104
100W x 4 @ 4 Ohm Stereo
200W x 4 @ 2 Ohm Stereo
400W x 2 Bridged @ 4 Ohms
(minimum impedance)
Maximum Fuse Rating
80
150
SYSTEM DIAGRAM 3
Four Way System with
Dual 4 Channel Amplifiers
D7 four channel amplifier
Channels 1/2 Highpass to tweeters
?
Channels 3/4 Bandpass to midrange drivers
?
AUX. OUT: Full-range to a
?
2nd 4 channel amplifier
D7 four channel amplifier
Channels 1/2 Bandpass to a pair
?
of midbass drivers
Channels 3/4 Lowpass to a pair of
?
bridged 8 Ohm subwoofers
19