3branch KURVE Инструкция по сборке Руководство - Страница 4
Просмотреть онлайн или скачать pdf Инструкция по сборке Руководство для Внутренняя отделка 3branch KURVE. 3branch KURVE 6 страниц. Desk w/hand crank adjustable height "t" base
Печатать страницу
MOUNTING
PLATE
THRU HOLE
FRONT & BACK
ADJ HEIGHT
COLUMN
MAIN BAR
COUNTERSINK
DOWN
STEP 6:
NOTE: BASE COLUMNS ARE LABELED "A" & "B" NEAR THE TOP.
ORIENATE COLUMNS SO THAT LABELS "A" & "B" ARE TURNED
TOWARDS THE WIDE OVERHANGING SIDE OF THE MOUNTING PLATES.
ORIENTATE MOUNTING PLATES SO THAT COUNTERSUNK SCREW
HOLES ARE OPPOSITE THE COLUMN.
ATTACH MOUNTING PLATES TO COLUMNS WITH M8 X 35MM
5MM HEX DRIVE SCREWS INSERTED THRU MOUNTING PLATES &
THREADING INTO TAPPED HOLES IN COLUMN END (4/END BASE).
STEP 7:
ORIENTATE MAIN BARS SO THAT COUNTERSUNK SCREW HOLES
ARE OPPOSITE THE COLUMN.
ATTACH MAIN BARS TO COLUMNS WITH M8 X 25MM 5MM HEX
DRIVE SCREWS INSERTED THRU COUNTERSUNK HOLES IN MAIN BAR
& THREADING INTO TAPPED HOLES IN COLUMN END (4/BASE END).
DRIVE ROD
STEP 9:
LOCATE DRIVE ROD BETWEEN COLUMNS.
ALIGN DRIVE ROD WITH HOLES IN COLUMNS & PUSH COLUMNS
TOGETHER.
KURVE COLLECTION
3branch
product design solutions
COUNTERSINK
UP
35MM SCREWS
HOLE TO
INSIDE
THRU HOLE
COLUMN "B"
FRONT & BACK
COLUMN "A"
25MM SCREWS
25MM SCREWS
P 847.291.3900
F 847.291.3901
www.3branch.com
THRU HOLE
FRONT & BACK
STEP 8:
TURN ASSEMBLED BASE ENDS FROM STEP 7 UPSIDE DOWN & SET
ON APRON/SUB-TOP ASSEMBLY.
NOTE: COLUMN "A" TO BE LOCATED ON LEFT END. ROTATE
COLUMN "A" SO THAT THE LABEL & HOLE IS TO THE INSIDE.
ROTATE COLUMN "B" SO THAT THE LABEL & HOLE IS TO
THE INSIDE. (LABELS WILL BE FACING EACH OTHER)
NOTE: THRU HOLES IN BOTH COLUMNS WILL BE ORIENTATED
FRONT TO BACK.
MOUNTING
SCREWS
STEP 10:
ALIGN BASE MOUNTING PLATES WITH PILOT HOLES LOCATED
IN BOTTOM FACE OF APRON/SUB-TOP ASSEMBLY.
ATTACH BASE ENDS TO BOTTOM FACE OF TOP PANEL WITH
#12 X 1" RHP WOOD SCREWS. INSERT SCREWS THRU HOLES
IN BASE MOUNTING PLATES & TIGHTEN INTO CORRESPONDING
PILOT HOLES LOCATED IN THE BOTTOM FACE OF THE SUB-TOP.
NOTE: FOUR SCREWS REQ'D FOR EACH BASE END.
DESCRIPTION:
KURVE DESK W/HAND CRANK ADJUSTABLE
HEIGHT "T" BASE
ASSEMBLY INSTRUCTIONS
DATE:
09.23.21
DWG #
SK-KU-DESK-ADJT-ASSEMBLY-01
"A"
"B"
REV #
0
SHEET
4 OF 6