Diamond H2O Reliant DRS4-EM-33 Руководство - Страница 5
Просмотреть онлайн или скачать pdf Руководство для Диспенсер для воды Diamond H2O Reliant DRS4-EM-33. Diamond H2O Reliant DRS4-EM-33 19 страниц. Reliant drs4 series single tank water softener
Печатать страницу- 1. Table of Contents
- 2. Place the Tanks Near a Water Source
- 3. Setting up the Tank
- 4. Connect the Brine Tank
- 5. Connect the Valves to the Water Source
- 6. Electrical
- 7. Start up the System for the First Time
- 8. Bypass Valve Operations
- 9. Main Operating States
- 10. Program the Valve
- 11. Troubleshooting
- 12. System Specifications
- 13. Error Codes
D. SLOWLY, pour the correct amount of resin
into the tank. Again, try to keep the media
level by carefully rocking the tank back and
forth.
E. Fill the rest of the tank with water to prevent
air from getting in the tanks and potentially
losing media.
F. Verify that there is a large O-ring on the
control valve(s) adapter base.
G. Place the control valve on the tank, making
sure that the distributor tube fits into the
bottom of the control valve.
4. Tighten the control valve onto the tank to the
point that it is snug. Double check that the valve
is in a correct position to be able to install the
plumbing.
5. Connect the brine tank.
A. Remove the ties on the brine line hose (included in the brine tank).
B. Remove the well cap and connect one end of the brine line hose to
the brine line connection (Shown in Figure 11) of the brine tank.
Tighten the brine line hose to the brine line connection by turning
the cap of the brine line connection clockwise by hand. Make sure
that no air can get into the line, or the softener will not regenerate
properly.
Figure 11: Brine Well Picture
C. Safely dispose of any leftover tubing.
D. Fill the brine tank with salt.
Figure 10: Resin Tank Diagram
Well Cap
Brine Line Connection
Distributer
Tube
Resin
Gravel
Distributer
Basket & Radials
Figure 12: Brine Tank
Diagram
pg. 4