Diamond Lustre COBRA-H-DLC Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Скребок Diamond Lustre COBRA-H-DLC. Diamond Lustre COBRA-H-DLC 11 страниц.

OPERATION

Inspect the machine, hoses, and cleaning tools for cleanliness and completeness.

Fill the Solution Tank with warm water. Using warm water may be a benefit in cleaning effectiveness,

but do not use hot water (above 130

value of between 6 and 9. High pH detergents and/or acid rinses will accelerate the wear of the seals

and will void the warranty.

Plug in the power cords. Do not connect both cords to the same outlet. If you are certain the cords

are on separate circuits, turn the Heat switch on. CAUTION: using the Heat switch when the cords

are on the same circuit may cause the circuit breaker in the wall to trip. NOTE: the cord with no red

sleeve powers the Heat Exchanger. The cord with the red sleeve powers the vacuums and pump.

Attach the spray hose to the solution quick disconnect on the front of the machine and attach the

vacuum hose to the hose barb on the recovery tank. Attach the other ends of the hoses to the

cleaning tool.

Allow the heat exchanger two minutes to reach operating temperature.

Turn the pump on. Turn the vacuum on. NOTE: the pump has a built in pressure switch; the

pump runs only when you are spraying.

Begin cleaning using the correct hoses and tool.

Use defoamer in the recovery tank any time foaming occurs.

Monitor the water level in the solution tank. Do not let the pump run dry.

10 When the solution tank gets low, turn off the pump, fill the solution tank, empty and clean the

recovery tank.

11 When finished with the job, remove any unused solution from the solution tank, and run a few gallons of

clean water through the system to rinse out any detergent.

Prior to using the machine, always check that the float filter is clean and the ball can travel freely. When the

recovery tank is full, the ball float will rise and will shut off the vacuum flow to prevent any more water from

entering the tank. Turn off the vacuum, and empty the recovery tank. NOTE: if foam is present or if the ball

float is prevented from rising, the float will not be able to stop the air flow, and the tank may over fill.

CAUTION!

To avoid vacuum motor damage, always make sure the float filter is clean and the ball can travel freely prior to

using the machine. And always use a defoamer when foaming occurs.

F+/ 54

C) in the tank. Add liquid cleaning solution with a pH