HP 201723-B21 - HP StorageWorks Modular SAN Array 1000 Hard Drive Руководство по администрированию - Страница 21

Просмотреть онлайн или скачать pdf Руководство по администрированию для Переключатель HP 201723-B21 - HP StorageWorks Modular SAN Array 1000 Hard Drive. HP 201723-B21 - HP StorageWorks Modular SAN Array 1000 Hard Drive 40 страниц. Storageworks modular smart array controller, cache, and battery replacement instructions
Также для HP 201723-B21 - HP StorageWorks Modular SAN Array 1000 Hard Drive: Справочное руководство (48 страниц), Примечание к выпуску (13 страниц), Инструкции по быстрому запуску (8 страниц), Примечание к выпуску (8 страниц), Примечание к выпуску (8 страниц), Краткое руководство по эксплуатации (7 страниц), Примечание к выпуску (5 страниц), Примечание к выпуску (5 страниц), Инструкции по замене (4 страниц)

Conﬁguring the HP Provider server

Install and conﬁgure the Windows 2003 server that will run the HP VDS Provider software as follows:

If it is not already present, install the Windows 2003 Server OS on the server that will run the

HP Provider software.

Install a Fibre Channel host bus adapter (HBA) card into the server according to the HBA

manufacturer's instructions.

Install the HBA driver and utility software onto the server according to the HBA manufacturer's

instructions. HP tested drivers are available from HP Support. Follow the README ﬁle that comes

with the driver for installation.

Connect the server to the disk array via the built-in Fibre Channel fabric switch, if present, or an

external switch. Conﬁgure the switch, including zoning if required, according to the manufacturer's

instructions. For helpful information on SAN construction, see the HP StorageWorks SAN Design

Reference Guide. To locate this guide, visit the HP Manuals web site listed in the front of this book

under

If desired, connect the server to the corporate Ethernet LAN (optional). A ﬁrewall is recommended

but optional. Be sure the ﬁrewall is open between the MSA host and the HP Provider server.

Install MPIO software on the VDS Provider server according to the MPIO Installation Guide.

Complete the rest of conﬁguration in this chapter and then install the required HP VDS Provider

software on the server as explained in "Chapter 3 Installation.

Conﬁguring the disk array and optional host

Ensure the disk array has been fully installed and conﬁgured. Install the Array Conﬁguration Utility

software on the optional host, if desired. For details, refer to the HP Array Conﬁguration Utility User

Guide. Make sure the license for the MPIO software, if used, is installed according to the MPIO Installation

Guide. Ensure the array is connected through a FC switch to the Provider server as explained previously.

NOTE:

When using the VDS framework to create and manage LUNs, the LUNs should be the same size as the

physical disk size. You can make LUNs smaller than a physical disk (or disks, if spanning multiple disks),

but any space left over on the physical disk(s) cannot be used. For example, if you have three 36

GB drives totalling 108 GB and you create a LUN of 20 GB spanning all three disks, the remaining

88 GB are unusable.

documentation. Search for the link to "HP StorageWorks SAN."

HP Modular Smart Array FC VDS Hardware Provider administration guide