HP 376227-B21 - ProLiant InfiniBand 4x Fabric Copper Switch Руководство по установке - Страница 12
Просмотреть онлайн или скачать pdf Руководство по установке для Переключатель HP 376227-B21 - ProLiant InfiniBand 4x Fabric Copper Switch. HP 376227-B21 - ProLiant InfiniBand 4x Fabric Copper Switch 28 страниц. Fabric clustering system 24-port 4x fabric copper switch installation guide, march 2005
Также для HP 376227-B21 - ProLiant InfiniBand 4x Fabric Copper Switch: Белая книга (13 страниц), Руководство по внедрению (9 страниц)
Печатать страницу
HP-UX Integrity Installation Overview & Planning
Install HP Fabric Clustering System Switches
Install HP Fabric Clustering System Switches
This section describes how to install the switch in a standard HP rack.
If the switch is already installed in a rack, proceed to "Remove Shipping Sleeve" on page 14.
Requirements
In addition to the accessories provided with the switch, you should have:
•
T-10 and T-25 Torx screwdrivers.
•
A second person for the installation. Installing the switch with only one person is very difficult.
Rack Mount Preparation
Prior to mounting the switch in a rack:
1. Check the slot in the rack for 1U clearance.
2. Open the box, remove the switch, rail brackets, and parts bag.
3. Place the switch on a secure, clean surface.
4. Open the plastic bag containing mounting parts.and locate:
•
(12) T-10 Torx screws for attaching the rails to the switch.
•
(8) T-25 Torx screws and clips for attaching the rails to the rack.
NOTE
It is highly recommend that two people install the switch, but it can be installed with one,
however it may be difficult to support and align the switch correctly in the rack rails with only
one person.
Installing the Switch
Step 1. Take one set of sliding brackets and separate them. Each side arrives with the sliding rail
assembled to a fixed rail. They need to be separated prior to attaching to the switch.
Figure 1-6 Fixed and Sliding Rails
Rails separated
12
Rails as packaged
Sliding rail
Fixed rail to attach to switch
Chapter 1