AQUATECH EDGE Pro Fuji X-T5 Руководство по эксплуатации - Страница 7
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Аксессуары для фотоаппаратов AQUATECH EDGE Pro Fuji X-T5. AQUATECH EDGE Pro Fuji X-T5 9 страниц.
Печатать страницуbottom right back corner.
3. Repeat process for 20 seconds then 30 seconds.
Cleaning and storage
Please perform all these cleaning tips without your
camera and lens installed.
•
With your Water Housing assembled wash the
outside off with fresh water. *Do not get the inside
wet.
•
With the clips locked down and the lens port on
slide the locking tabs back and forth while holding
the EDGE under fresh water. This will help wash
away any sand or debris. (See below diagram)
•
Dry off the EDGE with a clean towel and unlock the
clips. If you have access to an air gun gently blow
underneath the clips. If you do not have access to an
air gun you can use water pressure to flush out the
area. Just make sure not to get any water inside the
Water Housing. (Pictures will be shown)
•
While holding the EDGE under fresh water push all
the buttons and turn all the shafts.
•
While holding the EDGE under fresh water push and
turn the AF-Shutter buttons.
•
If you are using a M3 pistol make sure to remove it
after each use to clean away any debris or salt water.
DO
•
Clean the outside of your Water Housing with
fresh water after each use.
•
Wipe away any debris that may have gathered on
the threads, buttons, or O-Ring grooves.
•
Regularly take off and clean with fresh water any
accessories you may purchase (i.e. Pistol or Flash
Mount) to help keep corrosion from occurring.
•
Carefully wipe down the inside of the Water
Housing with a damp cloth. Make sure not to get
any of the electronics wet.
DO NOT
•
Do not store your housing fully clamped down for
long periods of time. Doing this will put unneeded
strain on your Clips and O-Rings.
•
Do not leave your Water Housing gear in
temperatures greater than 50 C (125 F)
•
Do not use alcohol-based products to clean the
Back Plate or port element as this may damage the
product.
•
Do not leave any accessories like Pistol Grips, Poles
or Flash Mounts attached on the Housing while
storing. Doing so can cause them to seize up and be
extremely difficult to remove.
Do not travel with your Water Housing clamped
•
down with Lens Ports attached. Remove all parts
and safely store.
Using your EDGE Water Housing underwater
For best results please make sure you have carefully
followed all initial setup instructions prior to taking
your EDGE Water Housing underwater.
6