3Com 10BASE-2 (BNC Руководство по установке - Страница 4

Просмотреть онлайн или скачать pdf Руководство по установке для Переключатель 3Com 10BASE-2 (BNC. 3Com 10BASE-2 (BNC 6 страниц. Unterminated ethernet 10base-2 (bnc) module

Печатать страницу
The LANplex system will automatically reset when a module has been
installed with the power on.
If you physically change the configuration of the system after defining an IP
interface, the port designated for that interface may no longer be valid. You
may have to redefine the interface. For information on defining an IP inter-
face, see the Administration Console User Guide for your LANplex system.
Installing the
To install the new module into the LANplex system, perform the following
Module
steps:
1
Ensure that you are properly grounded.
2
Remove the module from its antistatic bag.
WARNING: If the system is powered on when you are replacing the module,
do not insert any metal objects, such as a screwdriver or a finger wearing
jewelry, in the open slot. This could cause burns or other bodily harm.
3
Place the module between the guides of the selected slot and slide the
module into the chassis. See the figure below.
ERROR
LANplex 2500
R
Power
Run
Processor Power
Fan
Temp
Config
Green = Active
Yellow = Error
Unterminated
Unterminated
10BASE-2 (BNC)
option module
ERROR
R
LANplex 2500
Power
Run
Processor Power
Fan
Temp
Config
Green = Active
Yellow = Error
Unterminated
Unterminated
10BASE-2 (BNC)
option module
PCMCIA
Inserted
Port Status
Board
Active
Error
Error
1
2
3
4
5
6
Board
Error
1
2
3
4
5
6
Feed-thru
terminator
PCMCIA
Inserted
Port Status
Board
Active
Error
Error
1
2
3
4
5
6
Board
Error
6
1
2
3
4
5
7
8
Port Status
Active
Error
Captive screw
7
8
7
8
Port Status
Active
Error
8
7
Captive screw