Aquatek ATUN1001 Руководство по эксплуатации и техническому обслуживанию - Страница 9

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Системы фильтрации воды Aquatek ATUN1001. Aquatek ATUN1001 10 страниц. Upflow neutralizers

Печатать страницу

Problem

Neutralizer overcorrects upon installa-

tion or after replenishment

Neutralizer fails to increase pH upon

installation

Neutralizer fails to increase pH after

being in service.

Excessive pressure drop.

Under normal circumstances removal of the fill-port head assembly should not be re-

quired. However, if it must be re- moved, disconnect the plumbing attached to the bypass

valve first. Then, rotate the fill-port head assembly to the left or counter-clockwise. Before

attempting any disassembly, pressure should be relieved by shutting off water to the sys-

tem and opening a faucet. Upon reassembly, all o-rings should be lubricated with silicone

grease. Reattach fill-port head assembly by rotating to the right or clockwise until fill-port

head assembly is seated to the tank hand tight. Reconnect the plumbing to the bypass

Trouble Shooting Guide

Solution

The inlet bypass can be partially closed to allow untreated

and treated water to mix to obtain desired pH level. Periodi-

cally test treated water pH and open bypass valve when pH

begins to drop.

Make sure bypass valve is closed.

Test water or have it tested via third party. If high hardness or

total dissolved sol-

ids (TDS), seek alternate means of treatment such as feeding

a solution of soda ash or caustic soda.

Check filter bed for cementing or channeling. Break channel-

ing or cementing with stiff rod or tubing.

Check untreated water for sediment, silt or sand. Install sand

trap or multiple cartridge filter prior to neutralizer.

IMPORTANT SERVICING NOTE:

valve.

UNITED WATER INC.

AtuN-S

quAtek

erieS

Ser

uide