Diamond Products CC1600 Руководство по эксплуатации - Страница 12
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Пила Diamond Products CC1600. Diamond Products CC1600 16 страниц. Wall saw
Печатать страницу1. If your saw does not operate properly, the following table may be used as a guide in
diagnosing and eliminating the problem. If you cannot fix it using this table, call our
service representative.
2. Before calling, be sure you can describe the problem clearly so our representative can
help you. Have this manual at hand.
TROUBLE
Saw does not move or
moves erratically.
Blade drive pressure
fluctuates.
Blade does not rotate
when valve is opened.
Saw motor leaks.
Coupling leaks.
Chapter 5
TROUBLESHOOTING
CAUSE
Rollers or slides out of
adjustment.
Rack is dirty.
Loose nut on Blade
Depth Control
Assembly
Loose nut on Manual
Travel Assembly
Travel Transfer
Assembly worm gear
mis-aligned.
Speed of motor is too
low.
Power unit is defective.
Blade is jammed in
cut.
Power unit is defective.
Motor seals are
defective.
Coupling is defective.
REMEDY
Adjust rollers and
slides.
Clean rack.
Remove assembly and
tighten nut using
loctite 262
Same as above
Remove assembly,
slide worm gear
against bearing and
tighten setscrew.
Change to a smaller
motor or increase
GPM.
Check power unit.
Remove blade from cut
and try again.
Check power unit.
Replace motor or
motor seal.
Replace coupling or
coupling seal.