Panasonic PT-CW230EA Руководство по эксплуатации - Страница 19
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Проектор Panasonic PT-CW230EA. Panasonic PT-CW230EA 25 страниц. Network operations
Печатать страницу
Using Web Browser (continued)
E-mail setting page (continued)
Examples: Type and contents of alert mail
When the projector has an abnormally, the following alert message are sent to the registered E-mail address
according to your selected condition. Administrator or user can take an efficient action quickly by receiving this
message. This is very useful to maintain and service the projector.
The following are examples of received message.
When internal PJ temperature is too high:
z
TITLE: Message from projector
Projector Model Name: model name
TCP/IP: 192.168.10.100 Projector Name: PT-CW230
It sends you following message.
* The Projector lamp is turned off, because internal projector temperature is too high.
Wait for the completion of the cooling process and make sure the projector has been turned into
Standby. Then turn the projector on again.
If the Indicator continues flashing, check the air filter for dust accumulation.
When PJ needs service:
z
TITLE: Message from projector
Projector Model Name: model name
TCP/IP: 192.168.10.100 Projector Name: PT-CW230
It sends you following message.
* Maintenance requirement from Projector is detected.
Check up LED status of projector and consult with the dealer.
MCI
3.3V
OK
MAIN
ALL
NG
•
The projector lamp was turned off, because the projector power circuit failed.
•
Unplug the AC power cord and plug it, and then turn on the projector once again to verify operation. If the problem still
persists, unplug the AC power cord and ask servicing to a qualified service personnel with the error information.
When PJ lamp replacement time is reached:
z
TITLE: Message from projector
Projector Model Name: model name
TCP/IP: 192.168.10.100 Projector Name: PT-CW230
It sends you following message.
* The projector lamp has reached replacement time.
Lamp ON 3000 h
•
Replace it with a new lamp immediately and reset the lamp counter. If the projector is used without resetting the lamp
counter, the alert mail is sent to users in every power-on of the projector. This alert mail will not be sent when unchecking
the mail sending condition "When PJ lamp replacement time is reached".
Error information
19