Diamond Tech International Diamond Laser 7000 Руководство по эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Пила Diamond Tech International Diamond Laser 7000. Diamond Tech International Diamond Laser 7000 6 страниц. Band saw
Печатать страницуOPERATING THE DIAMOND LASER 7000 SAW
A.
Starting and Stopping Saw
The power switch is located on the left side of the band saw.
Be sure the power switch is in the OFF position before
plugging in the DL7000. ( See Fig. 4)
B.
Adjusting Blade Tension
To adjust the blade tension, turn the Blade Tensioning Knob (A) located on
the top of the saw clockwise. The blade should be tight enough so the blade
twists only slightly on curved cuts, and not at all for straight cuts.
(See Fig. 3)
C.
Blade Alignment
If the blade is not centered on the top wheel, an adjustment in the tilt of the
top wheel may be necessary.
NOTE: The blade may not be centered on the lower wheel when the blade
is properly adjusted on the top wheel. (See Fig. 5)
1) If the blade is forward of center on the top wheel, loosen the Locking
Knob (B) and turn Adjusting Knob (C) clockwise. Rotate wheels by hand
and adjust until blade is centered on upper wheel. Retighten Locking
Knob. (See Fig. 3)
2) If the blade is to the back of the upper wheel, loosen the Locking
Knob (B) and turn Adjusting Knob (C) counter clockwise. Rotate wheel
by hand and adjust until blade is centered on upper wheel. Retighten
locking knob. (See Fig. 3)
D.
Adjusting Upper Blade
Guide Assembly
Never Adjust the Blade Guides or Assemblies while the saw is turned
on, or in motion.
The Upper Blade Guide Assembly (A) Fig. 7 should be placed as close to
the work material as possible, with no more than 1/4" between the material
and Blade Guide. To adjust height, loosen knob (A) Fig. 6 and slide Blade
Guide Assembly to the desired position. Retighten knob once correctly
placed.
E.
Adjusting Upper Blade Guide
Adjust Upper Blade guides with Blade in center of Roller bearings (B)
Fig. 7. Loosen hex bolts in Fig. 6 (B) to adjust left or right and retighten.
Loosen hex bolt (C) Fig. 8 to adjust Blade Depth in Roller bearings to 1/4
of Blade depth and retighten. Adjust blade backstop (C) Fig. 7
approximately 1/4 of Blade depth behind Blade. Use hex bolt (A) Fig. 8 to
adjust. Use hex bolt (B) Fig. 8 to adjust blade back stop left or right.
NOTE: Blade should not touch Backstop until pressure is applied with
material to be cut.
(FIG. 4)
4
(FIG. 3)
A
B
C
(FIG. 5)
A
B
(FIG. 6)
A
B
(FIG. 7)
C
A
B
(FIG. 8)
B
A
C