Diamond Traffic Products Pegasus Руководство по быстрой установке - Страница 2

Просмотреть онлайн или скачать pdf Руководство по быстрой установке для Кассовый аппарат Diamond Traffic Products Pegasus. Diamond Traffic Products Pegasus 3 страницы.

Печатать страницу

Version 1.1 9/10/2013



NOTE: Files with lowest numbers are always the oldest files.

Stop Data Recording and Retrieving Data Files

 If Display is blank, Press 'Enter' key. 2

 Press 'Enter' and using the Arrow key choose 'Yes' and Press 'Enter'.

 Display should indicate the file number that was closed. Press 'Enter'.

 Connect Serial Cable (9 pin) to DataHog.

 Connect Serial Cable to Pegasus serial port (black, round end).

 Verify Pegasus display says 'Serial Active'.

 Turn on DataHog. Green LED will blink while transferring files, and stop blinking (go solid

on) when finished.

 Turn off DataHog and disconnect serial cable from the Pegasus and the DataHog.

 Press #1 key. Display should show 'Start Collecting'.

 Press 'Enter' key until 'Tuning loops' is displayed. Then press 'Enter' one more time.

 Verify Traffic to the counts on the display. They should be in sync. After verification is

complete, press 'Enter' through the remaining prompts. The display will blank its self, this

is a sleep mode, and the counter is active and will start counting at the next full 15 min.

DO NOT TURN POWER OFF. Close the lid and re-secure.

Should the battery voltage drop below 6.2 volts, attach the battery charger to the Pegasus unit

for 24 to 48 hours to completely charge the battery, charging time is dependent upon the

condition and age of the battery. If power is available at the count location, counting does NOT

have to be interrupted while the battery is charging.

Checking the Status of a Pegasus Unit

 With the counter on press #3 key, followed by 'Enter'.

 Using the 'Enter' key, scroll through the Status screen and check the Battery Voltage.

If the battery voltage is below 6.2 the unit needs to be charged.

 Verify that the Assistant General Manager has successfully received and processed last

week's files.

Programming the Pegasus for Data Collection

The Pegasus may be programmed to collect Traffic Data by either the built-in Keypad or by

Centurion Parks and your computer. We will discuss using Centurion Software only in this quick

start guide; for details on using the keypad, please refer to your Field Users Operation Manual.

 Open Centurion software and connect the serial cable between the computer and the

Pegasus unit.

 Turn on the Pegasus and verify the display shows 'Serial Active'. Click on the round gray

button with the green arrow in it (upper left side of the toolbar) to begin scanning for the

counter. If a Password is required, the software will prompt you to enter it here. The

default Password is 'PASS'.

Diamond Traffic Products, Inc.

line of the display should read 'Stop Collecting'.

Pegasus: Quick Installation Guide

Page 2