Diamondback 500Sr Руководство пользователя - Страница 4

Просмотреть онлайн или скачать pdf Руководство пользователя для Велотренажер Diamondback 500Sr. Diamondback 500Sr 19 страниц. Fitness
Также для Diamondback 500Sr: Технический паспорт (2 страниц)

Печатать страницу

500Ub Upright Assembly Instructions (Continued)

cover using a 6mm Allen wrench.

Place the bottle holder on the console mast. Insert and tighten the two M5 x 12mm screws using a

Phillips screwdriver.

Snap the water bottle into the bottle holder.

Step 5: Handlebar Assembly

Insert the hand pulse harness through the opening on the left side

of the console mast and out the top of the console mast.

Set the handlebar in place and secure it using a clamp, an M7 x

P1.0 x 30mm bolt with a spring washer and ﬂ at washer on top

hole of the clamp and a T-shape Knob with a bushing, a ﬂ at wash-

er and spring washer on bottom hole of the clamp. As the bolt

and T-shape knob are tightened leave the same gap on top and

bottom.

Install the handlebar top and bottom covers by attaching them to

each other from the opening in the bottom of the bottom cover

using two M3 x 14mm Screws and one M5 x 25mm on each side

of each cover.

Step 6: Console Assembly

Insert the ends of the main wiring harness and hand pulse wiring harness,

trough the opening of the rear console cover.

Connect both plugs, from the main wiring harness and hand pulse wiring

harness, to the plug receptors on the backside of the console taking care to

install correctly (see plug alignment marks).

WIRING HARNESS INSTALLATION HINT: Any excess wiring must be carefully

inserted ("stored") back into the console mast before installing the console

onto the console mounting plate.

Attach the console to the console mounting plate with the four M5 x 10mm

screws on the top and bottom holes of the mounting plate using a Phillips

screwdriver.

Attach the rear console coverl to the back of the console using four M5 x 10mm screws using a Phil-

lips screwdriver.

Attach the right console plastic mount hood to console mast using one M5 x 14mm bolt and Phil-

lips screwdriver. The cover should sit above the plastic handlebar covers and below the mounting

brackter for the console

Attach the left console plastic mount hood to console mast using one M5 x 14mm bolt then to the

right cover using three M3 x 14mm screws and a Phillips screwdriver.

Step 7: Transformer Assembly

Plug transformer into plug receptor located on the rear of the unit

Plug the transformer into power outlet.

NOTE: Be sure to use the right transformer for your power outlet, 110V or 220V.

500Ub.Sr OM R1.indd 8-9

500Sr Recumbent Assembly Drawing

6/11/2008 9:54:21 AM