Panasonic 885170283862 Руководство пользователя - Страница 10
Просмотреть онлайн или скачать pdf Руководство пользователя для Стереосистема Panasonic 885170283862. Panasonic 885170283862 32 страницы.
Печатать страницу
█
Selecting a preset station
1
Press [PLAY MENU] repeatedly to select
"TUNEMODE".
2
Press [R, T] to select "PRESET" and then press
[OK].
3
Press [2/3] or [5/6] to select the preset
station.
Improving the sound quality
1
Press [PLAY MENU] repeatedly to select
"FM MODE".
2
Press [R, T] to select "MONO" and then press
[OK].
To cancel, select "STEREO".
"MONO" is also canceled when you change the
frequency.
To memorize the setting
Continue with step 4 of "Manual presetting".
Checking the signal status
Press [DISPLAY].
FM – – – –
The FM signal is weak.
The system is not tuned in to a station.
FM ST
The FM signal is in stereo.
FM MONO
"MONO" is selected as the "FM MODE".
The FM signal is in monaural.
FM allocation setting
This system can also receive FM broadcasts allocated in
0.1 MHz steps.
1
Press [RADIO].
2
Press and hold [RADIO/USB] on the main unit.
After a few seconds, the display panel shows the current
minimum radio frequency. Release the button when the
minimum frequency changes.
• To go back to the initial setting, do the above steps
again.
• Preset frequencies are erased after you change the
setting.
10
Clock and timers
Setting the clock
This is a 12-hour clock.
1
Press [SETUP] repeatedly to select "CLOCK".
2
Press [R, T] to set the time and then press [OK].
To check the time
Press [SETUP] repeatedly to select "CLOCK" and
then press [OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Play timer
(Except for Bluetooth
®
source)
You can set the timer to come on at a certain time to
wake you up.
Preparation
Set the clock.
1
Press [SETUP] repeatedly to select "TIMER ADJ".
2
Press [R, T] to set the start time and then press
[OK].
3
Do step 2 again to set the end time.
4
Press [R, T] to select the source you want to play
and then press [OK].
To start the timer
1
Press [SETUP] repeatedly to select "TIMER SET".
2
Press [R, T] to select "SET" and then press [OK].
"#" is shown.
To cancel, select "OFF".
The system must be switched off for the timer to
operate.
To check the setting
Press [SETUP] repeatedly to select "TIMER ADJ" and
then press [OK].
In standby mode, press [DISPLAY] two times.
Note:
•
The timer starts at a low volume and increases gradually to
the preset level.
•
The timer comes on at the set time every day if the timer is
on.
•
If you switch off the system and then switch on again while
a timer is in operation, the timer will not stop at the end
time.