Panasonic SA-AK980 Руководство по эксплуатации - Страница 22
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Стереосистема Panasonic SA-AK980. Panasonic SA-AK980 24 страницы.
Печатать страницу
Troubleshooting guide (continued)
■ Unit displays
"NO PLAY"
"F61"
"ERROR"
"ERROR" (during recording)
"VBR–"
"– –:– –" (during standby
mode)
"USB OVER CURRENT
ERROR"
"HI-SPEED CAN'T REC"
"DEVICE FULL"
System memory reset (Initialization)
When the following situations occur, refer to the instructions below to reset the memory:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
To reset system memory
1 Disconnect the AC power supply cord. (Wait at least 3 minutes before proceeding to step 2.)
2 While pressing and holding down [y/I, POWER] on the main unit, reconnect the AC power supply cord.
"– – – – – – – – –" appears on the display panel.
3 Release [y/I, POWER].
All the settings are returned to the factory preset.
You will need to reset the memory items.
Maintenance
If the surfaces are dirty
To clean this unit, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this unit.
• Before using chemically treated cloth, read the instructions that
came with the cloth carefully.
22
RQT8043
RQTX0273-2M_us.indd 22
RQTX0273-2M_us.indd 22
• Check the content.
• Only MP3 format fi les can be played.
• Check and correct the speaker cords connection.
If this does not fi x the problem, consult the dealer.
• Disconnect the USB device. Turn the unit off and then back on.
• Incorrect operation performed. Read the instructions and try again.
• You are not able to select other playback source (example: radio, USB and etc.) or press
[4 / 1] or [¡ / ¢] during recording.
Stop the recording function.
• You are not able to open the disc tray when recording from AM source.
• Select a suitable recording mode (128 KBPS or 192 KBPS) and resume recording.
• The unit cannot display the remaining play time for variable bit rate (VBR) tracks.
• You plugged the AC power supply cord in for the fi rst time or there was a power failure
recently.
• Set the time.
• The USB device is drawing too much power. Disconnect the USB device. Turn the unit off
and then back on.
• You cannot use high-speed recording while using analog mode. Change to digital mode or
use normal recording.
• You cannot perform recording because the total USB remaining REC (recording) time of
the USB device is less than the total time of music source.
Change to a USB device which has the appropriate recording time and perform the
recording again.
When moving the unit
1
Remove all discs.
2
Press [y/I, POWER] to turn the unit off.
3
Disconnect the AC power supply cord.
Page
—
—
7
—
—
14
—
16
—
—
18
—
16
16
12/21/09 12:22:42 PM
12/21/09 12:22:42 PM