EasyPro EC1300 Инструкции по эксплуатации, безопасность, гарантия - Страница 3

Просмотреть онлайн или скачать pdf Инструкции по эксплуатации, безопасность, гарантия для Системы фильтрации воды EasyPro EC1300. EasyPro EC1300 8 страниц. Eco-clear pressurized filters

Печатать страницу

8. Secure the prepared barb fittings to the filter inlet

(arrow pointing in) and outlet (arrow pointing out).

Be sure to use the gasket as shown and hand

tighten nut onto filter. Do not overtighten.

9. Connect the tubing from the pump to the barbed

fitting on the inlet of the filter and secure with a

clamp.

10. Connect the tubing for the waterfall to barbed

fitting on the outlet of the filter and secure with a

clamp.

11. Run the tubing to the waterfall and attach to a waterfall device if applicable. Burying

the tubing will produce the most natural look for your pond.

12. If the pressure filter unit is equipped with a UV

light make sure it is properly plugged into a GFCI

protected outlet. DO NOT operate the UV light until

the pump is running.

13. For units with UV, there is a connection at the

ballast to be made. Connect the 2-pin fittings by

aligning the ends properly and firmly pushing them

together. Secure by hand tightening the nut to

create a weatherproof seal. This connection is not

meant to be submersed but is good for outdoor

use.

14. Plug in the pump and UV. Observe the filter and

connections for any leaks.

15. Conceal your pressure filter and tubing with your choice of landscaping. Fake rocks

are a good option to hide the filter.

Operation Tips

Running the filtration system continuously is the best way to keep your pond looking its

best. Once installed the filter will take a few weeks to build up sufficient nitrifying bacteria

in the system.

To maximize the filter's performance and avoid ineffectiveness or damage to the filter, be

sure to match the flow rate with the filter's specifications.

These filters are not to be used in the winter during freezing conditions. Be sure to

disconnect and drain the filter to store in a warmer location for the winter.

Step 8

Step 13