EasyPro Cabrio CLED4 Инструкции по эксплуатации, безопасность, гарантия
Просмотреть онлайн или скачать pdf Инструкции по эксплуатации, безопасность, гарантия для Осветительное оборудование EasyPro Cabrio CLED4. EasyPro Cabrio CLED4 4 страницы. Color changing led light
Печатать страницуCabrio Color Changing LED Light
Instructions for Operation • Safety • Warranty
Thank you for purchasing EasyPro's Cabrio color changing LED light. With this
LED light you can illuminate a pond or waterfall, highlight a deck or patio and
extend the enjoyment of your entire landscape in the evening hours. This light is
fully submersible and may be used in or out of water.
Safety and Electrical Connections
1.
Always disconnect the electrical supply before handling, maintaining,
repairing or installing any pond equipment.
2. Light must be attached to a 12 volt AC UL listed transformer.
3. Never connect the lights directly to a 110 volt or higher outlet.
4. Connect the transformer to a 110 volt receptacle that is protected by a
Ground Fault Circuit Interrupter.
5. Do not modify wiring in any way, quick plug ends must stay intact and
should not be replaced with terminals. DO NOT modify the white antenna on
the control module. Do not submerge control module.
6. All electrical work must be performed by a qualified technician. Always
follow the National Electrical Code (NEC) or the Canadian Electrical Code as
well as all local, state and provincial codes. Failure to follow manufacturer's
installation instructions may result in electrical shock, fire hazard, personal
injury or death, damaged equipment, provide unsatisfactory performance
and will void manufacturer's warranty.
Installation of LED Light
1. Before installing the product check for damaged or missing parts. Contact
EasyPro immediately if pieces are missing or damaged.
2. Be sure the power is disconnected before installing the light.
3. Determine desired location to place the LED light.
Note: Be sure to consider that individual diodes cannot be replaced at the
end of their life. Permanent settings may not be the best option in the case
that the entire LED fixture must be replaced.
CLED4
lighting series
by EasyPro Pond Products