EasyPro WFL2 Инструкции по эксплуатации, безопасность, гарантия - Страница 5
Просмотреть онлайн или скачать pdf Инструкции по эксплуатации, безопасность, гарантия для Осветительное оборудование EasyPro WFL2. EasyPro WFL2 8 страниц. Fountain light kit, stainless steel, warm white led light kits, two-light or three-light kits for use on easypro 1/2 and 1 hp aqua fountains or kasco 1/2 to 2 hp vfx, af or jf series fountains
Печатать страницуLED Three Light Kit Assembly Instructions
for 2 hp Kasco VFX, AF and JF Series Units
Actual light fixture may vary slightly from fixtures below.
1. For 2 hp Kasco units use the 3/4" pan head
screws from hardware pack labelled LKH-KBW
with nylock nut and smaller washer. Put screw
through the bottom of the bracket supplied with
the Kasco float. Then line it up in hole on light
bracket and secure with washer and nylock nut
as shown in Figure 1. Attach to brackets on 2 hp
Kasco in three locations seen in Figure 2.
2. Connect pigtails to three way cord splitter (three
x 1). To do this, be sure the pigtails go around the
motor screen in an orderly way so all lights can
be connected without twisting. When connecting
cords, be sure the o-ring is present in the female
portion of the connectors. (Figure 3) Push pigtails
into splitter and secure with 1/2 turn quick
connect nut on splitter. (Figure 4)
3. Connect main cord to the remaining end of the
splitter section. Be sure the o-ring is present
(Figure 3) and secure cords with 1/2 turn quick
connect nut (Figure 4). Multiple cords can be
connected up to 300' long between the light
fixtures and the control unit.
4. The main cord MUST BE SECURED to the float
of the fountain. Use plastic cable ties included in
your kit to do this. This acts as a strain relief for
the cords.
5. Adjust the angle of the light fixtures based on the
spray pattern being used. Tip in toward center
for narrower pattern and tip out slightly for wider
pattern.
6. Plug the main cable into the pigtail of the mounted
controller unit. Be sure to mount the weatherproof
controller with timer in a secure location near a
power supply and plug into 115 volt outlet.
See "Setting the Timer" for detailed instructions
on the controller.
7. Over time the LED lights may appear dimmer than when new. This is caused
by algae or sediment on light lens. This can easily be removed with a small
brush (a toothbrush works great).
5
Figure 1
Figure 2
o-ring
Figure 3
Figure 4