Bionaire BD10S-CN Памятка по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Памятка по эксплуатации для Осушитель Bionaire BD10S-CN. Bionaire BD10S-CN 8 страниц. Digital dehumidifier
Печатать страницу
F E AT U R E S - O P E R AT I O N S
23. CAUTION: In order to avoid a hazard due to
inadvertent resetting of the thermal cutout, this
appliance must not be supplied through an external
switching device, such as a timer, or connected to a
circuit that is regularly switched on and off by the
utility.
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
HOW YOUR DEHUMIDIFIER WORKS
Your Bionaire
dehumidifier draws moisture laden air
®
through the intake grills on the appliance. Humid air
passes through refrigerated coils where the moisture is
removed and collected in the water reservoir.
For optimum performance, it is not recommended to use
this appliance in environments where the temperature
exceeds 37 °C or is lower than 5 °C.
The unit should only be used indoors in such areas as a
living room or bedroom. Never use it outdoors. Make
sure doors and windows are closed before using the
appliance.
PRE-OPERATING INSTRUCTIONS
1. Select a location for your dehumidifier, on a flat/
level surface, about 4 inches (10cm) away from the
wall.
2. Place unit on a stable and flat floor surface. If the
floor surface is not even, there is a risk the unit
might be unstable or topple over. Also, it may result
in excessive vibration and noise.
3. Plug the power cord into a 120V AC electrical outlet.
OPERATING INSTRUCTIONS
1. Plug unit into an appropriate electrical outlet. The
unit will beep 3 times.
2. To start the unit, turn the knob to the desired
humidity level. You may adjust the humidity to a
level between 40% and 80% relative humidity.
3. To turn the unit off, turn the knob to Off (O).
HUMIDITY CONTROL
If the unit humidity level sensor detects humidity levels in
the environment that are lower than the selected
humidity level, the compressor will shut off and the fan
will work on low speed. The humidity level of the
environment must be higher than the humidity level
selected in order for the unit to start operating again.
AUTOMATIC DEFROSTING
If the room temperature drops down to 16° C or lower,
the unit's temperature sensor will turn the compressor to
off for 10 minutes. The defrost light "
The unit will resume operation for 40 minutes. If the
temperature is still below 16° C then the unit will keep
defrosting until the temperature has risen above 16° C or
turn off.
WATER FULL PROTECTION & AUTO-SHUTOFF
When the tank is full, the unit will sound an alarm
beeping 10 times (for about 5 seconds). The tank full
light "
" will go on and the unit will shut off
automatically. This indicates that it is time to empty the
tank before using the unit again. Once the empty tank is
placed back into the unit, it will take up to 3 minutes for
the dehumidifier compressor to work again. This is a
protection feature. If you wish to restart the unit without
waiting, unplug it from the electrical outlet and plug it in
again.
Water Drip Protection
When the tank is removed for emptying, this device will
keep the condensed water that continues to drip. Once
the tank is placed back in the unit, it will release this
water into the tank.
Continuous Drainage
For added user convenience, this dehumidifier includes a
hose that can be attached to it to operate with continuous
drainage. To use it, simply remove the drain plug located in
the back of the unit and connect the PVC hose that comes
with the unit. Find a suitable location for the unit where the
open end of the hose can drain the outgoing water into an
appropriate receptacle or outside of your home, far enough
away from the foundation to ensure proper drainage. The
unit will now direct water from the bypass port and through
the hose, rather than into the tank.
" will go on.